Hi All. I have more questions now.
Our card has DVB-T zl10353. Befor start encoder need set its out to Z-state. How to I can do it? This is my last big problem. Startup step by step: Call zarlink to set Z-state of a bus. Configure TS port of the saa7134 to PARALLEL_PS and config other regs Configure DMA of a TS Prepare settings for uPD61151 encoder Enable MPEG out of the uPD61151 by GPIO pin of the saa7134 Start DMA and TS Start encoder Stop step by step: Stop encoder Stop DMA and TS Disable MPEG out by GPIO pin of the saa7134 Zarlink and encoder connected to same bus and has different TS config. I need know who want use TS: zarlink or encoder. Now to I can do it? > Um, what is the 'Z state' of a bus? Write special value to command register of the zl10353. The chip disconnect internal bus from output bus. This bus used for send MPEG TS data from zl10353 to saa7134. uPD61151 and zl10353 connected to the same bus. At one time only one chip can send MPEG TS data to the saa7134. When DVB-T mode zl10353 send date, uPD61151 disconnected from a bus. When MPEG2 encode mode, uPD61151 send date, zl10353 disconnected from a bus. With my best regards, Dmitry. -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
