On 02/26/2018 03:27 AM, Douglas Fischer wrote:
> Fixed si470x_start() disabling the interrupt signal, causing tune
> operations to never complete. This does not affect USB radios
> because they poll the registers instead of using the IRQ line.
>
> Stylistic and comment changes from v2.
>
> Signed-off-by: Douglas Fischer <fischerdougl...@gmail.com>
> ---
>
> diff -uprN linux.orig/drivers/media/radio/si470x/radio-si470x-common.c
> linux/drivers/media/radio/si470x/radio-si470x-common.c
> --- linux.orig/drivers/media/radio/si470x/radio-si470x-common.c
> 2018-01-15 21:58:10.675620432 -0500
> +++ linux/drivers/media/radio/si470x/radio-si470x-common.c 2018-02-25
> 19:16:31.785934211 -0500
> @@ -377,8 +377,11 @@ int si470x_start(struct si470x_device *r
> goto done;
>
> /* sysconfig 1 */
> - radio->registers[SYSCONFIG1] =
> - (de << 11) & SYSCONFIG1_DE; /* DE*/
> + radio->registers[SYSCONFIG1] |=
> SYSCONFIG1_RDSIEN|SYSCONFIG1_STCIEN|SYSCONFIG1_RDS;
> + radio->registers[SYSCONFIG1] &= ~SYSCONFIG1_GPIO2;
> + radio->registers[SYSCONFIG1] |= (0x01 << 2); /* GPIO2 */
Yes, but what does this do? Enable GPIO2? The header defines two bits for
GPIO1/2/3, but it doesn't say what those bits mean. So the question here is
what it means to set bit 2 to 1 and bit 3 to 0? The header doesn't give any
information about that, nor does this comment.
Regards,
Hans
> + if (de)
> + radio->registers[SYSCONFIG1] |= SYSCONFIG1_DE;
> retval = si470x_set_register(radio, SYSCONFIG1);
> if (retval < 0)
> goto done;
>
