Pci_enable_device() will set device power state to D0, so it's no need to do it again in bnx2x_init_dev(). Also remove redundant PM Cap find code, because pci core has been saved the pci device pm cap value.
Signed-off-by: Yijing Wang <[email protected]> Cc: Eilon Greenstein <[email protected]> Cc: [email protected] Cc: [email protected] --- drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c | 4 +--- 1 files changed, 1 insertions(+), 3 deletions(-) diff --git a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c index b4c9dea..6ecd497 100644 --- a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c +++ b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c @@ -11959,7 +11959,7 @@ static int bnx2x_init_dev(struct bnx2x *bp, struct pci_dev *pdev, } if (IS_PF(bp)) { - bp->pm_cap = pci_find_capability(pdev, PCI_CAP_ID_PM); + bp->pm_cap = pdev->pm_cap; if (bp->pm_cap == 0) { dev_err(&bp->pdev->dev, "Cannot find power management capability, aborting\n"); @@ -12008,8 +12008,6 @@ static int bnx2x_init_dev(struct bnx2x *bp, struct pci_dev *pdev, } BNX2X_DEV_INFO("me reg PF num: %d\n", bp->pf_num); - bnx2x_set_power_state(bp, PCI_D0); - /* clean indirect addresses */ pci_write_config_dword(bp->pdev, PCICFG_GRC_ADDRESS, PCICFG_VENDOR_ID_OFFSET); -- 1.7.1 -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
