On 7/3/26 07:03, Gaurav Kohli wrote:
Enable Thermal Mitigation Device (TMD) support for PAS-managed CDSP and modem remote processors on platforms that expose the QMI TMD service.This adds per-platform TMD configuration in qcom_q6v5_pas for: - Hamoa (X1E80100) CDSP - Kodiak CDSP and modem - Lemans (SA8775P) CDSP - Talos CDSP - Monaco CDSP For each remoteproc, the configured TMD QMI instance ID is used to bind to the TMD service running on that subsystem (e.g. CDSP: 0x43, modem: 0x0). The driver then uses the corresponding TMD endpoint names ("cdsp_sw", "pa", "modem") for cooling-device registration. QMI TMD identifies mitigation endpoints by name, while DT thermal bindings reference cooling devices by id. This change provides the mapping between DT cooling indices and QMI TMD names, allowing remoteproc nodes with #cooling-cells to act as cooling devices in the thermal framework. With this in place, thermal policies can request mitigation from CDSP and modem subsystems via QMI under thermal pressure. Signed-off-by: Gaurav Kohli <[email protected]>
Reviewed-by: Daniel Lezcano <[email protected]>
