On Thu, Nov 6, 2025 at 12:11 PM Jason Wang <[email protected]> wrote:
>
> On Wed, Nov 5, 2025 at 4:02 PM Cindy Lu <[email protected]> wrote:
> >
> > Improve MAC address handling in mlx5_vdpa_set_attr() to ensure
> > that old MAC entries are properly removed from the MPFS table
> > before adding a new one. The new MAC address is then added to
> > both the MPFS and VLAN tables.
> >
> > Warnings are issued if deleting or adding a MAC entry fails, but
> > the function continues to execute in order to keep the configuration
> > as consistent as possible with the hardware state.
> >
> > This change fixes an issue where the updated MAC address would not
> > take effect until the qemu was rebooted
> >
> > Signed-off-by: Cindy Lu <[email protected]>
> > ---
> >  drivers/vdpa/mlx5/net/mlx5_vnet.c | 20 ++++++++++++++++++--
> >  1 file changed, 18 insertions(+), 2 deletions(-)
> >
> > diff --git a/drivers/vdpa/mlx5/net/mlx5_vnet.c 
> > b/drivers/vdpa/mlx5/net/mlx5_vnet.c
> > index e38aa3a335fc..4bc39cb76268 100644
> > --- a/drivers/vdpa/mlx5/net/mlx5_vnet.c
> > +++ b/drivers/vdpa/mlx5/net/mlx5_vnet.c
> > @@ -4067,10 +4067,26 @@ static int mlx5_vdpa_set_attr(struct vdpa_mgmt_dev 
> > *v_mdev, struct vdpa_device *
> >         down_write(&ndev->reslock);
> >         if (add_config->mask & (1 << VDPA_ATTR_DEV_NET_CFG_MACADDR)) {
> >                 pfmdev = pci_get_drvdata(pci_physfn(mdev->pdev));
> > -               err = mlx5_mpfs_add_mac(pfmdev, config->mac);
> > -               if (!err)
> > +               if (!is_zero_ether_addr(ndev->config.mac)) {
> > +                       if (mlx5_mpfs_del_mac(pfmdev, ndev->config.mac)) {
> > +                               mlx5_vdpa_warn(mvdev,"failed to delete old 
> > MAC %pM from MPFS table\n",
> > +                                       ndev->config.mac);
>
> Any reason we need to keep trying when we fail here?
>
sure will change this. i will reuse the code in hanle_ctrl_mac
> > +                       }
> > +               }
> > +               err = mlx5_mpfs_add_mac(pfmdev, (u8 *)add_config->net.mac);
> > +               if (!err) {
> > +                       mac_vlan_del(ndev, config->mac, 0, false);
> >                         ether_addr_copy(config->mac, add_config->net.mac);
> > +               } else {
> > +                       mlx5_vdpa_warn(mvdev,"failed to add new MAC %pM to 
> > MPFS table\n",
> > +                               (u8 *)add_config->net.mac);
> > +                       up_write(&ndev->reslock);
> > +                       return err;
> > +               }
> >         }
> > +       if (mac_vlan_add(ndev, ndev->config.mac, 0, false))
> > +               mlx5_vdpa_warn(mvdev,"failed to add new MAC %pM to vlan 
> > table\n",
> > +                              (u8 *)add_config->net.mac);
> >
> >         up_write(&ndev->reslock);
> >         return err;
> > --
> > 2.45.0
> >
>
> Thanks
>


Reply via email to