On Fri, Oct 10, 2025 at 11:30:43AM +0800, Wang Liang wrote:
> The jq command is used in vlan_bridge_binding.sh, if it is not supported,
> the test will spam the following log.
> 
>   # ./vlan_bridge_binding.sh: line 51: jq: command not found
>   # ./vlan_bridge_binding.sh: line 51: jq: command not found
>   # ./vlan_bridge_binding.sh: line 51: jq: command not found
>   # ./vlan_bridge_binding.sh: line 51: jq: command not found
>   # ./vlan_bridge_binding.sh: line 51: jq: command not found
>   # TEST: Test bridge_binding on->off when lower down                   [FAIL]
>   #       Got operstate of , expected 0
> 
> The rtnetlink.sh has the same problem. It makes sense to check if jq is
> installed before running these tests. After this patch, the
> vlan_bridge_binding.sh skipped if jq is not supported:
> 
>   # timeout set to 3600
>   # selftests: net: vlan_bridge_binding.sh
>   # TEST: jq not installed                                              [SKIP]
> 
> Signed-off-by: Wang Liang <[email protected]>
> ---
>  tools/testing/selftests/net/rtnetlink.sh           | 2 ++
>  tools/testing/selftests/net/vlan_bridge_binding.sh | 2 ++
>  2 files changed, 4 insertions(+)
> 
> diff --git a/tools/testing/selftests/net/rtnetlink.sh 
> b/tools/testing/selftests/net/rtnetlink.sh
> index dbf77513f617..163a084d525d 100755
> --- a/tools/testing/selftests/net/rtnetlink.sh
> +++ b/tools/testing/selftests/net/rtnetlink.sh
> @@ -1466,6 +1466,8 @@ usage: ${0##*/} OPTS
>  EOF
>  }
>  
> +require_command jq
> +
>  #check for needed privileges
>  if [ "$(id -u)" -ne 0 ];then
>       end_test "SKIP: Need root privileges"
> diff --git a/tools/testing/selftests/net/vlan_bridge_binding.sh 
> b/tools/testing/selftests/net/vlan_bridge_binding.sh
> index db481af9b6b3..e8c02c64e03a 100755
> --- a/tools/testing/selftests/net/vlan_bridge_binding.sh
> +++ b/tools/testing/selftests/net/vlan_bridge_binding.sh
> @@ -249,6 +249,8 @@ test_binding_toggle_off_when_upper_down()
>       do_test_binding_off : "on->off when upper down"
>  }
>  
> +require_command jq
> +
>  trap defer_scopes_cleanup EXIT
>  setup_prepare
>  tests_run
> -- 
> 2.34.1
> 

Reviewed-by: Hangbin Liu <[email protected]>

Reply via email to