Hi, Sandeep Maheswaram <[email protected]> writes: > This patch adds a shutdown callback to USB DWC QCOM driver to ensure that > it is properly shutdown in reboot/shutdown path. This is required > where SMMU address translation is enabled like on SC7180 > SoC and few others. If the hardware is still accessing memory after > SMMU translation is disabled as part of SMMU shutdown callback in > system reboot or shutdown path, then IOVAs(I/O virtual address) > which it was using will go on the bus as the physical addresses which > might result in unknown crashes (NoC/interconnect errors). > > Signed-off-by: Sandeep Maheswaram <[email protected]>
sounds like this is fixing a bug. Do you have a Fixes tag for it? Should
this go to stable?
> diff --git a/drivers/usb/dwc3/dwc3-qcom.c b/drivers/usb/dwc3/dwc3-qcom.c
> index c703d55..a930e06 100644
> --- a/drivers/usb/dwc3/dwc3-qcom.c
> +++ b/drivers/usb/dwc3/dwc3-qcom.c
> @@ -790,13 +790,11 @@ static int dwc3_qcom_probe(struct platform_device *pdev)
> return ret;
> }
>
> -static int dwc3_qcom_remove(struct platform_device *pdev)
> +static void __dwc3_qcom_teardown(struct dwc3_qcom *qcom)
> {
> - struct dwc3_qcom *qcom = platform_get_drvdata(pdev);
> - struct device *dev = &pdev->dev;
> int i;
>
> - of_platform_depopulate(dev);
> + of_platform_depopulate(qcom->dev);
>
> for (i = qcom->num_clocks - 1; i >= 0; i--) {
> clk_disable_unprepare(qcom->clks[i]);
> @@ -807,12 +805,27 @@ static int dwc3_qcom_remove(struct platform_device
> *pdev)
> dwc3_qcom_interconnect_exit(qcom);
> reset_control_assert(qcom->resets);
>
> - pm_runtime_allow(dev);
> - pm_runtime_disable(dev);
> + pm_runtime_allow(qcom->dev);
> + pm_runtime_disable(qcom->dev);
> +}
you can make the changes smaller by adding:
struct device *dev = qcom->dev;
The nothing else needs to change in this function ;-)
--
balbi
signature.asc
Description: PGP signature
