Using full paths to extend or override a device tree node is error prone since if there was a typo error, a new node will be created instead of extending the node as it was desired. This will lead to run-time errors that could be hard to detect.
A mistyped label on the other hand, will cause a dtc compile error (during build time). Signed-off-by: Krzysztof Kozlowski <[email protected]> --- arch/arm/boot/dts/exynos4210.dtsi | 36 +++++++++++++++---------------- 1 file changed, 17 insertions(+), 19 deletions(-) diff --git a/arch/arm/boot/dts/exynos4210.dtsi b/arch/arm/boot/dts/exynos4210.dtsi index 73360f29d53e..fddc661ded28 100644 --- a/arch/arm/boot/dts/exynos4210.dtsi +++ b/arch/arm/boot/dts/exynos4210.dtsi @@ -365,26 +365,24 @@ }; }; }; +}; - thermal-zones { - cpu_thermal: cpu-thermal { - polling-delay-passive = <0>; - polling-delay = <0>; - thermal-sensors = <&tmu 0>; - - trips { - cpu_alert0: cpu-alert-0 { - temperature = <85000>; /* millicelsius */ - }; - cpu_alert1: cpu-alert-1 { - temperature = <100000>; /* millicelsius */ - }; - cpu_alert2: cpu-alert-2 { - temperature = <110000>; /* millicelsius */ - }; - }; - }; - }; +&cpu_alert0 { + temperature = <85000>; /* millicelsius */ +}; + +&cpu_alert1 { + temperature = <100000>; /* millicelsius */ +}; + +&cpu_alert2 { + temperature = <110000>; /* millicelsius */ +}; + +&cpu_thermal { + polling-delay-passive = <0>; + polling-delay = <0>; + thermal-sensors = <&tmu 0>; }; &gic { -- 2.17.1
