From: Pratyush Yadav <[email protected]> The xSPI Profile 1.0 table specifies how many dummy cycles and address bytes are needed for the Read Status Register command in octal DTR mode. Use that information to send the correct Read SR command.
Signed-off-by: Pratyush Yadav <[email protected]> --- drivers/mtd/spi-nor/core.c | 10 ++++++++++ 1 file changed, 10 insertions(+) diff --git a/drivers/mtd/spi-nor/core.c b/drivers/mtd/spi-nor/core.c index 6dfc54ff83be..185ca1fa2b50 100644 --- a/drivers/mtd/spi-nor/core.c +++ b/drivers/mtd/spi-nor/core.c @@ -379,6 +379,11 @@ static int spi_nor_read_sr(struct spi_nor *nor, u8 *sr) SPI_MEM_OP_NO_DUMMY, SPI_MEM_OP_DATA_IN(1, sr, 1)); + if (spi_nor_protocol_is_dtr(nor->reg_proto)) { + op.addr.nbytes = nor->params->rdsr_addr_nbytes; + op.dummy.nbytes = nor->params->rdsr_dummy; + } + spi_nor_spimem_setup_op(nor, &op, nor->reg_proto); ret = spi_mem_exec_op(nor->spimem, &op); @@ -410,6 +415,11 @@ static int spi_nor_read_fsr(struct spi_nor *nor, u8 *fsr) SPI_MEM_OP_NO_DUMMY, SPI_MEM_OP_DATA_IN(1, fsr, 1)); + if (spi_nor_protocol_is_dtr(nor->reg_proto)) { + op.addr.nbytes = nor->params->rdsr_addr_nbytes; + op.dummy.nbytes = nor->params->rdsr_dummy; + } + spi_nor_spimem_setup_op(nor, &op, nor->reg_proto); ret = spi_mem_exec_op(nor->spimem, &op); -- 2.27.0
