From: Douglas Anderson <[email protected]> commit 2de0b42da263c97d330d276f5ccf7c4470e3324f upstream.
There are certain cases, notably when transitioning between sleep and active state, when Broadcom SDIO WiFi cards will produce errors on the SDIO bus. This is evident from the source code where you can see that we try commands in a loop until we either get success or we've tried too many times. The comment in the code reinforces this by saying "just one write attempt may fail" Unfortunately these failures sometimes end up causing an "-EILSEQ" back to the core which triggers a retuning of the SDIO card and that blocks all traffic to the card until it's done. Let's disable retuning around the commands we expect might fail. Cc: [email protected] #v4.18+ Signed-off-by: Douglas Anderson <[email protected]> Acked-by: Adrian Hunter <[email protected]> Reviewed-by: Arend van Spriel <[email protected]> Acked-by: Kalle Valo <[email protected]> Signed-off-by: Ulf Hansson <[email protected]> Signed-off-by: Greg Kroah-Hartman <[email protected]> --- drivers/net/wireless/broadcom/brcm80211/brcmfmac/sdio.c | 4 ++++ 1 file changed, 4 insertions(+) --- a/drivers/net/wireless/broadcom/brcm80211/brcmfmac/sdio.c +++ b/drivers/net/wireless/broadcom/brcm80211/brcmfmac/sdio.c @@ -667,6 +667,8 @@ brcmf_sdio_kso_control(struct brcmf_sdio brcmf_dbg(TRACE, "Enter: on=%d\n", on); + sdio_retune_crc_disable(bus->sdiodev->func1); + wr_val = (on << SBSDIO_FUNC1_SLEEPCSR_KSO_SHIFT); /* 1st KSO write goes to AOS wake up core if device is asleep */ brcmf_sdiod_writeb(bus->sdiodev, SBSDIO_FUNC1_SLEEPCSR, wr_val, &err); @@ -719,6 +721,8 @@ brcmf_sdio_kso_control(struct brcmf_sdio if (try_cnt > MAX_KSO_ATTEMPTS) brcmf_err("max tries: rd_val=0x%x err=%d\n", rd_val, err); + sdio_retune_crc_enable(bus->sdiodev->func1); + return err; }
