Add one IIO channel named "charge_vol" to read the charge voltage for the SC27XX fuel gauge controller.
Signed-off-by: Baolin Wang <[email protected]> --- .../devicetree/bindings/power/supply/sc27xx-fg.txt | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) diff --git a/Documentation/devicetree/bindings/power/supply/sc27xx-fg.txt b/Documentation/devicetree/bindings/power/supply/sc27xx-fg.txt index fc35ac5..0a5705b 100644 --- a/Documentation/devicetree/bindings/power/supply/sc27xx-fg.txt +++ b/Documentation/devicetree/bindings/power/supply/sc27xx-fg.txt @@ -9,8 +9,8 @@ Required properties: "sprd,sc2731-fgu". - reg: The address offset of fuel gauge unit. - battery-detect-gpios: GPIO for battery detection. -- io-channels: Specify the IIO ADC channel to get temperature. -- io-channel-names: Should be "bat-temp". +- io-channels: Specify the IIO ADC channels to get temperature and charge voltage. +- io-channel-names: Should be "bat-temp" or "charge-vol". - nvmem-cells: A phandle to the calibration cells provided by eFuse device. - nvmem-cell-names: Should be "fgu_calib". - monitored-battery: Phandle of battery characteristics devicetree node. @@ -47,8 +47,8 @@ Example: compatible = "sprd,sc2731-fgu"; reg = <0xa00>; battery-detect-gpios = <&pmic_eic 9 GPIO_ACTIVE_HIGH>; - io-channels = <&pmic_adc 5>; - io-channel-names = "bat-temp"; + io-channels = <&pmic_adc 5>, <&pmic_adc 14>; + io-channel-names = "bat-temp", "charge-vol"; nvmem-cells = <&fgu_calib>; nvmem-cell-names = "fgu_calib"; monitored-battery = <&bat>; -- 1.7.9.5
