Add a new compatible for sun4i-i2s driver to handle some
SoCs that have a reset line that must be asserted/deasserted.

This new compatible, "allwinner,sun6i-a31-i2s", requires two
properties:
        - resets: phandle to the reset line
        - reset-names: the name of the reset line ("rst").
Except these differences, the compatible is identical to previous one
which will not handle a reset line.

Signed-off-by: Mylène Josserand <[email protected]>
---
 .../devicetree/bindings/sound/sun4i-i2s.txt        | 23 ++++++++++++++++++++++
 1 file changed, 23 insertions(+)

diff --git a/Documentation/devicetree/bindings/sound/sun4i-i2s.txt 
b/Documentation/devicetree/bindings/sound/sun4i-i2s.txt
index 7a2c0945fd22..f673206e309b 100644
--- a/Documentation/devicetree/bindings/sound/sun4i-i2s.txt
+++ b/Documentation/devicetree/bindings/sound/sun4i-i2s.txt
@@ -7,6 +7,7 @@ Required properties:
 
 - compatible: should be one of the following:
    - "allwinner,sun4i-a10-i2s"
+   - "allwinner,sun6i-a31-i2s" for controller with reset lines
 - reg: physical base address of the controller and length of memory mapped
   region.
 - interrupts: should contain the I2S interrupt.
@@ -19,7 +20,13 @@ Required properties:
    - "mod" : module clock for the I2S controller
 - #sound-dai-cells : Must be equal to 0
 
+Required properties for the following compatibles:
+               - "allwinner,sun6i-a31-i2s"
+- resets: phandle to the reset line for this codec
+- reset-names: Contains the reset signal name "rst"
+
 Example:
+For "allwinner,sun4i-a10-i2s":
 
 i2s0: i2s@01c22400 {
        #sound-dai-cells = <0>;
@@ -32,3 +39,19 @@ i2s0: i2s@01c22400 {
               <&dma SUN4I_DMA_NORMAL 3>;
        dma-names = "rx", "tx";
 };
+
+For "allwinner,sun6i-a31-i2s":
+
+dai: dai@01c22c00 {
+       #sound-dai-cells = <0>;
+       compatible = "allwinner,sun6i-a31-i2s";
+       reg = <0x01c22c00 0x200>;
+       interrupts = <GIC_SPI 29 IRQ_TYPE_LEVEL_HIGH>;
+       clocks = <&ccu CLK_BUS_CODEC>, <&ccu CLK_AC_DIG>;
+       clock-names = "apb", "mod";
+       resets = <&ccu RST_BUS_CODEC>;
+       reset-names = "rst";
+       dmas = <&dma 15>, /* AUDIO_CODEC port */
+               <&dma 15>; /* AUDIO_CODEC port */
+       dma-names = "rx", "tx";
+};
-- 
2.11.0

Reply via email to