On Friday 06 January 2017 10:03 AM, David Lechner wrote:
> + beeper {
> + compatible = "pwm-beeper";
> + pinctrl-names = "default";
> + pinctrl-0 = <&ehrpwm0b_pins>, <&_pins>;
> + pwms = <&ehrpwm0 1 0 0>;
> + enable-gpios = <&gpio 111 GPIO_ACTIVE_HIGH>;
Since the enable-gpios binding for pwm beeper is still not accepted, can
you drop the property or the node itself (if that makes more sense)?
> +&spi0 {
> + status = "okay";
> + pinctrl-names = "default";
> + pinctrl-0 = <&spi0_pins>, <&spi0_cs0_pin>, <&spi0_cs3_pin>;
> +
> + flash@0 {
> + compatible = "n25q128a13", "jedec,spi-nor";
> + reg = <0>;
> + spi-max-frequency = <50000000>;
> + ti,spi-wdelay = <8>;
> +
> + /* Partitions are based on the official firmware from LEGO */
> + partitions {
> + #address-cells = <1>;
> + #size-cells = <1>;
> + partition@0 {
> + label = "U-Boot";
> + reg = <0 0x40000>;
> + };
> +
> + partition@40000 {
> + label = "U-Boot Env";
> + reg = <0x40000 0x10000>;
> + };
> +
> + partition@50000 {
> + label = "Kernel";
> + reg = <0x50000 0x200000>;
> + };
> +
> + partition@250000 {
> + label = "Filesystem";
> + reg = <0x250000 0xa50000>;
> + };
> +
> + partition@cb0000 {
> + label = "Storage";
> + reg = <0xcb0000 0x2f0000>;
> + };
> + };
> + };
> +
> + adc@3 {
> + compatible = "ti-ads7957";
So looks like this works because of_register_spi_device() sets up
modalias of spi device from compatible string. I am fine with it, just
highlighting it here to make sure this is acceptable practice. I did not
really find any precedence for using SPI device name as compatible
property in existing DTS files.
> + reg = <3>;
> + spi-max-frequency = <10000000>;
> + refin-supply = <&adc_ref>;
> + };
Rest of the patch looks good to me.
Thanks,
Sekhar
