Gabriel,

On 11/04/2016 09:52 AM, [email protected] wrote:
From: Gabriel Fernandez <[email protected]>

This patch adds lsi / lse oscillators. These clocks can be use by
RTC clocks.
The clock drivers needs to disable the power domain write protection using
syscon / regmap to enable these clocks.


Is it the same than you sent in last series ? If yes I will take it directly as review has already been done.

regards
Alex

Signed-off-by: Gabriel Fernandez <[email protected]>
---
 arch/arm/boot/dts/stm32f429.dtsi | 18 ++++++++++++++++++
 1 file changed, 18 insertions(+)

diff --git a/arch/arm/boot/dts/stm32f429.dtsi b/arch/arm/boot/dts/stm32f429.dtsi
index 336ee4f..2700449 100644
--- a/arch/arm/boot/dts/stm32f429.dtsi
+++ b/arch/arm/boot/dts/stm32f429.dtsi
@@ -56,6 +56,18 @@
                        compatible = "fixed-clock";
                        clock-frequency = <0>;
                };
+
+               clk-lse {
+                       #clock-cells = <0>;
+                       compatible = "fixed-clock";
+                       clock-frequency = <32768>;
+               };
+
+               clk-lsi {
+                       #clock-cells = <0>;
+                       compatible = "fixed-clock";
+                       clock-frequency = <32000>;
+               };
        };

        soc {
@@ -185,6 +197,11 @@
                        interrupts = <1>, <2>, <3>, <6>, <7>, <8>, <9>, <10>, <23>, <40>, <41>, 
<42>, <62>, <76>;
                };

+               pwrcfg: power-config@40007000 {
+                       compatible = "syscon";
+                       reg = <0x40007000 0x400>;
+               };
+
                pin-controller {
                        #address-cells = <1>;
                        #size-cells = <1>;
@@ -340,6 +357,7 @@
                        compatible = "st,stm32f42xx-rcc", "st,stm32-rcc";
                        reg = <0x40023800 0x400>;
                        clocks = <&clk_hse>;
+                       st,syscfg = <&pwrcfg>;
                };

                dma1: dma-controller@40026000 {

Reply via email to