On Thu, 2016-10-27 at 17:38 +0100, Ed Blake wrote:
> Add a set_ldisc function to enable/disable IrDA SIR mode according to
> the new line discipline.

Thanks for the patch.

Consider that not all implementations based on 8250_dw support IRDA
feature. I suppose you need to read capability register bits 6 and 7,
set flag and then based on the value accept or reject IRDA mode.

P.S. Use -n when prepare patches to link them if you consider them
dependent.

> 
> Signed-off-by: Ed Blake <[email protected]>
> ---
>  drivers/tty/serial/8250/8250_dw.c | 17 +++++++++++++++++
>  1 file changed, 17 insertions(+)
> 
> diff --git a/drivers/tty/serial/8250/8250_dw.c
> b/drivers/tty/serial/8250/8250_dw.c
> index 459d726..7dd5369 100644
> --- a/drivers/tty/serial/8250/8250_dw.c
> +++ b/drivers/tty/serial/8250/8250_dw.c
> @@ -53,6 +53,8 @@
>  /* Helper for fifo size calculation */
>  #define DW_UART_CPR_FIFO_SIZE(a)     (((a >> 16) & 0xff) * 16)
>  
> +/* DesignWare specific register fields */
> +#define DW_UART_MCR_SIRE             BIT(6)
>  
>  struct dw8250_data {
>       u8                      usr_reg;
> @@ -254,6 +256,20 @@ static void dw8250_set_termios(struct uart_port
> *p, struct ktermios *termios,
>       serial8250_do_set_termios(p, termios, old);
>  }
>  
> +static void dw8250_set_ldisc(struct uart_port *p, struct ktermios
> *termios)
> +{
> +     unsigned int mcr = p->serial_in(p, UART_MCR);
> +
> +     if (termios->c_line == N_IRDA)
> +             mcr |= DW_UART_MCR_SIRE;
> +     else
> +             mcr &= ~DW_UART_MCR_SIRE;
> +
> +     p->serial_out(p, UART_MCR, mcr);
> +
> +     serial8250_do_set_ldisc(p, termios);
> +}
> +
>  /*
>   * dw8250_fallback_dma_filter will prevent the UART from getting just
> any free
>   * channel on platforms that have DMA engines, but don't have any
> channels
> @@ -392,6 +408,7 @@ static int dw8250_probe(struct platform_device
> *pdev)
>       p->iotype       = UPIO_MEM;
>       p->serial_in    = dw8250_serial_in;
>       p->serial_out   = dw8250_serial_out;
> +     p->set_ldisc    = dw8250_set_ldisc;
>  
>       p->membase = devm_ioremap(dev, regs->start,
> resource_size(regs));
>       if (!p->membase)

-- 
Andy Shevchenko <[email protected]>
Intel Finland Oy

Reply via email to