Mistake while sending v2, sorry for the noise.
On Fri, May 13, 2016 at 03:14:46PM +0200, Ludovic Desroches wrote: > Activating wakeup event is not enough to get a wakeup signal. The > corresponding events have to be enabled in the Interrupt Status Enable > Register too. > > Signed-off-by: Ludovic Desroches <[email protected]> > --- > Hi, > > I just updated sdhci_enable_irq_wakeups() not sdhci_disable_irq_wakeups() > because I don't think it is necessary to configure SDHCI_INT_ENABLE at this > step, it will be done with sdhci_init() or sdhci_enable_card_detection(). > > While I was writing this patch, several questions came to my mind: > - Is the naming correct? wakeup signal is not an irq. 'enable_irq_wakeups' can > be a bit confusing. > - If we want to wakeup from irq, we may have to set SDHCI_INT_ENABLE and > SDHCI_SIGNAL_ENABLE and not rely on a previous configuration, isn't it? > > Regards > > Ludovic > > drivers/mmc/host/sdhci.c | 26 ++++++++++++++++++-------- > 1 file changed, 18 insertions(+), 8 deletions(-) > > diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c > index b284924..6fc69ed 100644 > --- a/drivers/mmc/host/sdhci.c > +++ b/drivers/mmc/host/sdhci.c > @@ -2638,18 +2638,28 @@ static irqreturn_t sdhci_thread_irq(int irq, void > *dev_id) > > \*****************************************************************************/ > > #ifdef CONFIG_PM > +/* > + * To enable wakeup events, the corresponding events have to be enabled in > + * the Interrupt Status Enable register too. See 'Table 1-6: Wakeup Signal > + * Table' in the SD Host Controller Standard Specification. > + */ > void sdhci_enable_irq_wakeups(struct sdhci_host *host) > { > - u8 val; > - u8 mask = SDHCI_WAKE_ON_INSERT | SDHCI_WAKE_ON_REMOVE > - | SDHCI_WAKE_ON_INT; > + u8 wakeup_val; > + u8 wakeup_mask = SDHCI_WAKE_ON_INSERT | SDHCI_WAKE_ON_REMOVE | > + SDHCI_WAKE_ON_INT; > + u32 irq_val = SDHCI_INT_CARD_INSERT | SDHCI_INT_CARD_REMOVE | > + SDHCI_INT_CARD_INT; > > - val = sdhci_readb(host, SDHCI_WAKE_UP_CONTROL); > - val |= mask ; > + wakeup_val = sdhci_readb(host, SDHCI_WAKE_UP_CONTROL); > + wakeup_val |= wakeup_mask; > /* Avoid fake wake up */ > - if (host->quirks & SDHCI_QUIRK_BROKEN_CARD_DETECTION) > - val &= ~(SDHCI_WAKE_ON_INSERT | SDHCI_WAKE_ON_REMOVE); > - sdhci_writeb(host, val, SDHCI_WAKE_UP_CONTROL); > + if (host->quirks & SDHCI_QUIRK_BROKEN_CARD_DETECTION) { > + wakeup_val &= ~(SDHCI_WAKE_ON_INSERT | SDHCI_WAKE_ON_REMOVE); > + irq_val &= ~(SDHCI_INT_CARD_INSERT | SDHCI_INT_CARD_REMOVE); > + } > + sdhci_writeb(host, wakeup_val, SDHCI_WAKE_UP_CONTROL); > + sdhci_writel(host, irq_val, SDHCI_INT_ENABLE); > } > EXPORT_SYMBOL_GPL(sdhci_enable_irq_wakeups); > > -- > 2.5.0 >
