Hi, On 21.03.2016 21:18, Mark Brown wrote:
Currently we only attempt to set the voltage during constraints application if an exact voltage is specified. Extend this so that if the currently set voltage for the regualtor is outside the bounds set in
regulator
constraints we will move the voltage to the nearest constraint, raising to the minimum or lowering to the maximum as needed. This ensures that drivers can probe without the hardware being driven out of spec. Reported-by: Ivaylo Dimitrov <[email protected]> Signed-off-by: Mark Brown <[email protected]> --- Untested so far, will give it a spin later/tomorrow. drivers/regulator/core.c | 32 +++++++++++++++++++++++++------- 1 file changed, 25 insertions(+), 7 deletions(-)
Patch 1 does not apply cleanly on 4.5-rc5, so I applied it by hand, however, you may add:
Tested-by: Ivaylo Dimitrov <[email protected]> Thanks, Ivo
