Hi, I am new to this whole dvb thing.
Basically, I want to capture the TS off the tv-tuner card (DVB-C). I have successfully used the czap & scan to get the channels configuration. After that, I "make" the dvbstream: & run it to capture the TS off the card as follows: > dvbstream 8192 -o > test.ts However in my output I get: dvbstream v0.5 - (C) Dave Chapman 2001-2004 Released under the GPL. Latest version available from http://www.linuxstb.org/ Setting filter for PID 8192 Output to stdout Streaming 1 stream Caught signal 2 - closing cleanly. where the captured ts file: test.ts is 0 bytes. I noticed from other discussions that the normal output would have something like this: Using DVB card "ST STV0297 DVB-C" tuning DVB-C to 618000000, srate=XXXX000 polling.... Getting frontend event FE_STATUS: polling.... Getting frontend event FE_STATUS: FE_HAS_SIGNAL FE_HAS_LOCK FE_HAS_CARRIER FE_HAS_VITERBI FE_HAS_SYNC Event: Frequency: 628600000 SymbolRate: XXXX000 FEC_inner: 0 Bit error rate: 0 Signal strength: 546 SNR: 1433 FE_STATUS: However, I do not have any of this. Where did I went wrong? Thank you. Reagrds, hy
_______________________________________________ linux-dvb mailing list [email protected] http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
