On Thu 25 Feb 12:27 CST 2021, Thara Gopinath wrote:

> Qualcomm crypto engine allows for IV registers and status register
> to be concatenated to the output. This option is enabled by setting the
> RESULTS_DUMP field in GOPROC  register. This is useful for most of the
> algorithms to either retrieve status of operation or in case of
> authentication algorithms to retrieve the mac. But for ccm
> algorithms, the mac is part of the output stream and not retrieved
> from the IV registers, thus needing a separate buffer to retrieve it.
> Make enabling RESULTS_DUMP field optional so that algorithms can choose
> whether or not to enable the option.
> Note that in this patch, the enabled algorithms always choose
> RESULTS_DUMP to be enabled. But later with the introduction of ccm
> algorithms, this changes.
> 
> Signed-off-by: Thara Gopinath <thara.gopin...@linaro.org>

Reviewed-by: Bjorn Andersson <bjorn.anders...@linaro.org>

Regards,
Bjorn

> ---
>  drivers/crypto/qce/common.c | 11 +++++++----
>  1 file changed, 7 insertions(+), 4 deletions(-)
> 
> diff --git a/drivers/crypto/qce/common.c b/drivers/crypto/qce/common.c
> index 7c3cb483749e..2485aa371d83 100644
> --- a/drivers/crypto/qce/common.c
> +++ b/drivers/crypto/qce/common.c
> @@ -88,9 +88,12 @@ static void qce_setup_config(struct qce_device *qce)
>       qce_write(qce, REG_CONFIG, config);
>  }
>  
> -static inline void qce_crypto_go(struct qce_device *qce)
> +static inline void qce_crypto_go(struct qce_device *qce, bool result_dump)
>  {
> -     qce_write(qce, REG_GOPROC, BIT(GO_SHIFT) | BIT(RESULTS_DUMP_SHIFT));
> +     if (result_dump)
> +             qce_write(qce, REG_GOPROC, BIT(GO_SHIFT) | 
> BIT(RESULTS_DUMP_SHIFT));
> +     else
> +             qce_write(qce, REG_GOPROC, BIT(GO_SHIFT));
>  }
>  
>  #ifdef CONFIG_CRYPTO_DEV_QCE_SHA
> @@ -219,7 +222,7 @@ static int qce_setup_regs_ahash(struct 
> crypto_async_request *async_req)
>       config = qce_config_reg(qce, 1);
>       qce_write(qce, REG_CONFIG, config);
>  
> -     qce_crypto_go(qce);
> +     qce_crypto_go(qce, true);
>  
>       return 0;
>  }
> @@ -380,7 +383,7 @@ static int qce_setup_regs_skcipher(struct 
> crypto_async_request *async_req)
>       config = qce_config_reg(qce, 1);
>       qce_write(qce, REG_CONFIG, config);
>  
> -     qce_crypto_go(qce);
> +     qce_crypto_go(qce, true);
>  
>       return 0;
>  }
> -- 
> 2.25.1
> 

Reply via email to