On 19/03/15 13:02, Andre Wolokita wrote: > Hi guys, > > I'm experiencing a strange issue when booting up u-boot on my older ezkit > (red board, pre-1.0). Yesterday I updated u-boot and openocd to the 1.0.0.BR > tag and build u-boot. I tried running u-boot on a 1.0 ezkit but found that > the board was faulty. Then I went back to using the old ezkit, booting via > JTAG, init.elf, u-boot, all that stuff, and everything was still working > fine. Today when I get in to work I try to boot up again and get no response > over the serial connection. When I check the Griffin registers on GDB, I find > that the PC doesn't move from its boot position (0x5094 or thereabouts). > Basically the ezkit will no longer boot into uboot. I've tried both my LPC > and HPC boards and neither work. Unfortunately I don't have access to a 1.0 > board as we only have one and it is being used by someone else. > > Any ideas? > > Regards, > > Andre. > Oops! Just ignore this - it was meant for the blackfin mailing list. I guess that's what happens when you haven't had your first coffee and forget that most Linux lists begin with linux-*.
-- Andre Wolokita ([email protected]) Design Engineer, Analog Devices Australia Pty Ltd Unit 3, 97 Lewis Road, Wantirna, Victoria, 3152, AUSTRALIA Direct: +61 3 9881 9933 Main: +61 3 9881 9999 Fax: +61 3 9881 9988 Web: www.analog.com/au Embedded DSP software for multimedia & telecommunications. This communication is proprietary and confidential. -- To unsubscribe from this list: send the line "unsubscribe linux-crypto" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
