On Mon, Nov 14, 2011 at 16:52, adreas Polyxronopoulos
<[email protected]> wrote:
> So you mean to change the decoder side which in my case is the mplayer right?
My fault, I misunderstood your scenario.
> The total duration of the stream after starting the muxing.out(my
> executable) is about 7sec, but using the ffmpeg-command is around 52.6 sec.
> I think the problem is in the encoder-streamer side not at the decoder side,
> correct my if i am wrong. I am calculating the PTS as follows:
> struct timeval tv;
> struct timezone tz;
> struct tm *tm;
> gettimeofday(&tv, &tz);
> tm = localtime(&tv.tv_sec);
> int now = tm->tm_hour * 3600 * 1000 + tm->tm_min * 60 * 1000 +
> tm->tm_sec * 1000 + tv.tv_usec / 1000;
> picture->pts = av_rescale_q(now, (AVRational){1, 10}, c->time_base);
You should fill in pts based on the desired frame rate, not
timeofday(). Also, your encoder which will replace the ffpmeg command
line should read the frames at expected rate (to avoid overflow of
rtp).
> thanks a lot for the reply.
> Adreas Polychronopoulos
Cheers,
Alex
_______________________________________________
Libav-user mailing list
[email protected]
http://ffmpeg.org/mailman/listinfo/libav-user
