Additionally updated config to drop CONFIG_MTD_NAND_OXNAS and ignore missing oxnas_nand module.
-- You received this bug notification because you are a member of Kernel Packages, which is subscribed to linux in Ubuntu. https://bugs.launchpad.net/bugs/1691369 Title: Zesty update to 4.10.16 stable release Status in linux package in Ubuntu: New Status in linux source package in Zesty: In Progress Bug description: SRU Justification Impact: The upstream process for stable tree updates is quite similar in scope to the Ubuntu SRU process, e.g., each patch has to demonstrably fix a bug, and each patch is vetted by upstream by originating either directly from a mainline/stable Linux tree or a minimally backported form of that patch. The 4.10.16 upstream stable patch set is now available. It should be included in the Ubuntu kernel as well. git://git.kernel.org/ TEST CASE: TBD The following patches from the 4.10.16 stable release shall be applied: * 9p: fix a potential acl leak * drm/sti: fix GDP size to support up to UHD resolution * hwmon: (it87) Fix pwm4 detection for IT8620 and IT8628 * mtd: nand: Add OX820 NAND hardware dependency * tpm: fix RC value check in tpm2_seal_trusted * tmp: use pdev for parent device in tpm_chip_alloc * crypto: caam - fix error path for ctx_dma mapping failure * crypto: caam - don't dma_map key for hash algorithms * power: supply: lp8788: prevent out of bounds array access * cpupower: Fix turbo frequency reporting for pre-Sandy Bridge cores * powerpc/perf: Fix perf_get_data_addr() for power9 DD1 * powerpc/perf: Handle sdar_mode for marked event in power9 * powerpc/mm: Fixup wrong LPCR_VRMASD value * powerpc/powernv: Fix opal_exit tracepoint opcode * powerpc/mm: Fix build break when CMA=n && SPAPR_TCE_IOMMU=y * powerpc/ftrace: Fix confusing help text for DISABLE_MPROFILE_KERNEL * powerpc: Correctly disable latent entropy GCC plugin on prom_init.o * power: supply: bq24190_charger: Fix irq trigger to IRQF_TRIGGER_FALLING * power: supply: bq24190_charger: Call set_mode_host() on pm_resume() * power: supply: bq24190_charger: Install irq_handler_thread() at end of probe() * power: supply: bq24190_charger: Call power_supply_changed() for relevant component * power: supply: bq24190_charger: Don't read fault register outside irq_handle_thread() * power: supply: bq24190_charger: Handle fault before status on interrupt * arm64: dts: r8a7795: Mark EthernetAVB device node disabled * arm: dts: qcom: Fix ipq board clock rates * arm64: remove wrong CONFIG_PROC_SYSCTL ifdef * arm64: Improve detection of user/non-user mappings in set_pte(_at) * spi: armada-3700: Remove spi_master_put in a3700_spi_remove() * leds: ktd2692: avoid harmless maybe-uninitialized warning * ARM: pxa: ezx: fix a910 camera data * ARM: dts: NSP: GPIO reboot open-source * ARM: dts: imx6sx-udoo-neo: Fix reboot hang * ARM: OMAP5 / DRA7: Fix HYP mode boot for thumb2 build * ARM: OMAP3: Fix smartreflex platform data regression * ARM: dts: am57xx-idk: tpic2810 is on I2C bus, not SPI * ARM: dts: sun7i: lamobo-r1: Fix CPU port RGMII settings * mwifiex: debugfs: Fix (sometimes) off-by-1 SSID print * mwifiex: remove redundant dma padding in AMSDU * mwifiex: Avoid skipping WEP key deletion for AP * mwifiex: don't enable/disable IRQ 0 during suspend/resume * mwifiex: set adapter->dev before starting to use mwifiex_dbg() * iwlwifi: mvm: properly check for transport data in dump * iwlwifi: mvm: don't restart HW if suspend fails with unified image * iwlwifi: mvm: overwrite skb info later * iwlwifi: pcie: don't increment / decrement a bool * iwlwifi: pcie: trans: Remove unused 'shift_param' * iwlwifi: pcie: fix the set of DMA memory mask * iwlwifi: mvm: fix reorder timer re-arming * iwlwifi: mvm: Use aux queue for offchannel frames in dqa * iwlwifi: mvm/pcie: adjust A-MSDU tx_cmd length in PCIe * iwlwifi: mvm: fix pending frame counter calculation * iwlwifi: mvm: fix references to first_agg_queue in DQA mode * iwlwifi: mvm: synchronize firmware DMA paging memory * iwlwifi: mvm: writing zero bytes to debugfs causes a crash * iwlwifi: mvm: fix accessing fw_id_to_mac_id * x86/ioapic: Restore IO-APIC irq_chip retrigger callback * x86/pci-calgary: Fix iommu_free() comparison of unsigned expression >= 0 * x86/mpx: Re-add MPX to selftests Makefile * clk: Make x86/ conditional on CONFIG_COMMON_CLK * platform/x86: intel_pmc_core: fix out-of-bounds accesses on stack * kprobes/x86: Fix kernel panic when certain exception-handling addresses are probed * x86/platform/intel-mid: Correct MSI IRQ line for watchdog device * Revert "KVM: nested VMX: disable perf cpuid reporting" * KVM: nVMX: initialize PML fields in vmcs02 * KVM: nVMX: do not leak PML full vmexit to L1 * usb: dwc2: host: use msleep() for long delay * usb: host: ehci-exynos: Decrese node refcount on exynos_ehci_get_phy() error paths * usb: host: ohci-exynos: Decrese node refcount on exynos_ehci_get_phy() error paths * usb: chipidea: Only read/write OTGSC from one place * usb: chipidea: Handle extcon events properly * USB: serial: keyspan_pda: fix receive sanity checks * USB: serial: digi_acceleport: fix incomplete rx sanity check * USB: serial: ssu100: fix control-message error handling * USB: serial: io_edgeport: fix epic-descriptor handling * USB: serial: ti_usb_3410_5052: fix control-message error handling * USB: serial: ark3116: fix open error handling * USB: serial: ftdi_sio: fix latency-timer error handling * USB: serial: quatech2: fix control-message error handling * USB: serial: mct_u232: fix modem-status error handling * USB: serial: ch341: fix modem-status handling * USB: serial: io_edgeport: fix descriptor error handling * clk: rockchip: add "," to mux_pll_src_apll_dpll_gpll_usb480m_p on rk3036 * phy: qcom-usb-hs: Add depends on EXTCON * serial: 8250_omap: Fix probe and remove for PM runtime * scsi: qedi: Fix possible memory leak in qedi_iscsi_update_conn() * scsi: qedi: fix build error without DEBUG_FS * scsi: qla2xxx: Fix crash in qla2xxx_eh_abort on bad ptr * scsi: mac_scsi: Fix MAC_SCSI=m option when SCSI=m * scsi: smartpqi: fix time handling * MIPS: R2-on-R6 MULTU/MADDU/MSUBU emulation bugfix * brcmfmac: Ensure pointer correctly set if skb data location changes * brcmfmac: Make skb header writable before use * staging/lustre/llite: move root_squash from sysfs to debugfs * staging: wlan-ng: add missing byte order conversion * staging: emxx_udc: remove incorrect __init annotations * staging: lustre: ptlrpc: avoid warning on missing return * ALSA: hda - Fix deadlock of controller device lock at unbinding * sparc64: fix fault handling in NGbzero.S and GENbzero.S * tcp: do not underestimate skb->truesize in tcp_trim_head() * net: adjust skb->truesize in ___pskb_trim() * net: macb: fix phy interrupt parsing * geneve: fix incorrect setting of UDP checksum flag * bpf: enhance verifier to understand stack pointer arithmetic * bpf, arm64: fix jit branch offset related to ldimm64 * tcp: fix wraparound issue in tcp_lp * net: ipv6: Do not duplicate DAD on link up * net: usb: qmi_wwan: add Telit ME910 support * tcp: do not inherit fastopen_req from parent * ipv4, ipv6: ensure raw socket message is big enough to hold an IP header * rtnetlink: NUL-terminate IFLA_PHYS_PORT_NAME string * ipv6: initialize route null entry in addrconf_init() * ipv6: reorder ip6_route_dev_notifier after ipv6_dev_notf * bnxt_en: allocate enough space for ->ntp_fltr_bmap * bpf: don't let ldimm64 leak map addresses on unprivileged * net: mdio-mux: bcm-iproc: call mdiobus_free() in error path * openvswitch: Set internal device max mtu to ETH_MAX_MTU. * f2fs: sanity check segment count * xen: Revert commits da72ff5bfcb0 and 72a9b186292d * drm/hisilicon/hibmc: Fix wrong pointer passed to PTR_ERR() * drm: mxsfb: drm_dev_alloc() returns error pointers * drm/ttm: fix use-after-free races in vm fault handling * block: get rid of blk_integrity_revalidate() * Linux 4.10.16 To manage notifications about this bug go to: https://bugs.launchpad.net/ubuntu/+source/linux/+bug/1691369/+subscriptions -- Mailing list: https://launchpad.net/~kernel-packages Post to : kernel-packages@lists.launchpad.net Unsubscribe : https://launchpad.net/~kernel-packages More help : https://help.launchpad.net/ListHelp
