Am 21.01.23 um 08:03 schrieb Stefan G. Weichinger:
I will start by stopping one of my 2 kea-nodes, and then remove the VLAN
interfaces on the remaining one. Plus enable the DHCP-relay, plus adding
that fw-rule.
In kea I have to remove the various vlan-interfaces and edit the subnets
to all listen on the same and only LAN-interface.
Did my changes but today there are no more workers on site there so it's
a bit hard to test for me from remote.
Went back to the old setup for now.
questions around config:
Could I remove the separate interface lines from the subnets:
{
"interface": "enp0s31f6", # THIS LINE
"id": 3,
"subnet": "192.168.103.0/24",
In the first lines I already have:
{
"Dhcp4": {
"interfaces-config": {
"interfaces": [ "enp0s31f6" ],
"dhcp-socket-type": "raw",
"service-sockets-require-all": false,
"service-sockets-max-retries": 1000,
"service-sockets-retry-wait-time": 10000
},
That defines the interface anyway, right?
"dhcp-socket-type" is ok? "raw" seems to be the default anyway.
--
ISC funds the development of this software with paid support subscriptions.
Contact us at https://www.isc.org/contact/ for more information.
To unsubscribe visit https://lists.isc.org/mailman/listinfo/kea-users.
Kea-users mailing list
[email protected]
https://lists.isc.org/mailman/listinfo/kea-users
