https://bugs.kde.org/show_bug.cgi?id=489981
--- Comment #18 from Bernd <bern...@yahoo.com> --- (In reply to Jean-Baptiste Mardelle from comment #16) > @Bernd: I watched the video but the quality is very low and I cannot read > the track names on it, so hard to understand what you mean. Can you better > describe the issue with an annotated screenshot maybe? Sorry for that, J-B-M. I had to run it through Handbrake to keep the size below the 4MB limit of bugs.kde.org. What I did is this: * Add seven clips to the timeline * Switch to the Multicam tool and hit Play * I press the track numbers in sequence starting with 1, and going in reverse order after reaching 7, than up again * Once I run out of tracks, I reload the project and repeat this but this time scrubbing through the timeline and pressing the track numbers inthe same order (1-7, 7-1, 1-7, ...) The first thing I noted is that in the Multicam tool view in the project monitor, the number of the last track used (i.e. a clip was added to) is highlighted, and if I press 1 the first cut is made in track #7. The first cadence (1 thru 7) goes ok in the first pass but then gets out of sync. Perhaps pressing the number of a track that doesn't have a clip trips up Kdenlive, but this issue is most noticable in the second pass (scrubbing). The original screen recording (albeit it edited) is about 10MB. If you still need it, I can share it via opendesktop. -- You are receiving this mail because: You are watching all bug changes.
