https://bugs.kde.org/show_bug.cgi?id=482939
damon.dev...@gmail.com changed:
What |Removed |Added
----------------------------------------------------------------------------
Ever confirmed|0 |1
Status|RESOLVED |REOPENED
Resolution|WORKSFORME |---
--- Comment #6 from damon.dev...@gmail.com ---
Sorry for the extremely late reply. A combination of things including a PC
failure had me forgetting about this until now. On the plus side, the new
laptop meant I was able to test this on a fresh install with an Intel GPU
instead of AMD. The same thing still happens on the new system.
Updated version numbers since it's been a couple months:
Linux/KDE Plasma: Arch Linux / Linux-Zen 6.9.3
KDE Plasma Version: 6.0.5
KDE Frameworks Version: 6.2.0
Qt Version: 6.7.1
(In reply to Nate Graham from comment #3)
> So you have two ultrawide 5120x1440 monitors, and you use the split screen
> feature to make each of them get exposed to the system as two 2560x1440
> monitors, so Plasma and KWin see four monitors instead of two? Do I have
> that right?
Correct. It just reports to the system that the max output resolution of each
port is 2560x1440 when I enable it
> And then when you disable this feature on either of the monitors under
> Plasma 6, they get reset to 2560x1440 instead of 5120x1440? Do I have that
> right as well?
This is partially correct. It just stays at whatever setting I had it on
previously. When I switch the monitor to 2560x1440 mode (from the monitor's
menu), it flips to the lower resolution just fine, but when I switch it back to
5120x1440 it's still at 2560x1440 when it reconnects. I'm not sure if Plasma
was assuming it was a different monitor on 5.27 or what could have caused this
to change on Plasma 6.
--
You are receiving this mail because:
You are watching all bug changes.
