Bspec and the code suggests that the interrupt signaled by IIR[7,5] (DISPLAY_PIPE_A/B_VBLANK) is a first level IRQ flag for the second level PIPEA/BSTAT[2] (Start of Vertical Blank) interrupt. Measuring the relative timings of when IIR[7] and PIPEASTAT[1,2] get set and checking the effect of unmasking different pipestat and IIR events shows that this isn't so:
First, ISR/IIR[7] gets set independently of PIPEASTAT[18] (Start of Vertical Blank Enable) or any other pipestat enable bit, so it isn't a first level IRQ bit showing the state of PIPEASTAT[2], but is connected directly to the timing generator. Second, setting only PIPEASTAT[18] and leaving all other pipestat events disabled, IIR[6] (DISPLAY_PIPE_A_EVENT) gets set close to the moment when PIPEASTAT[2] gets set, so the former is a first level interrupt flag for the latter. The bspec is rather unclear about this, but I also assume that IIR[6] signals all pipestat A events, except PIPEASTAT[31] (FIFO Under-run Status). Third, IIR[7] is set close to the moment when PIPEASTAT[1] (Framestart Interrupt) gets set, in the mode I used about 12usec after PIPEASTAT[2] and IIR[6] gets set. This means the IIR[7] isn't marking the start of vblank, but rather signals the framestart event. Based on the above, we don't need to unmask IIR[7] when waiting for start of vblank events, but we can rely on IIR[6] being always unmasked, which will signal when PIPEASTAT[2] gets set. Doing this will also get rid of the overhead of getting an interrupt and servicing IIR[7], which is atm raised always some time after IIR[6]/PIPEASTAT[2] is raised. Signed-off-by: Imre Deak <[email protected]> --- drivers/gpu/drm/i915/i915_irq.c | 14 -------------- 1 file changed, 14 deletions(-) diff --git a/drivers/gpu/drm/i915/i915_irq.c b/drivers/gpu/drm/i915/i915_irq.c index b226ae6..137ac65 100644 --- a/drivers/gpu/drm/i915/i915_irq.c +++ b/drivers/gpu/drm/i915/i915_irq.c @@ -2297,18 +2297,11 @@ static int valleyview_enable_vblank(struct drm_device *dev, int pipe) { drm_i915_private_t *dev_priv = (drm_i915_private_t *) dev->dev_private; unsigned long irqflags; - u32 imr; if (!i915_pipe_enabled(dev, pipe)) return -EINVAL; spin_lock_irqsave(&dev_priv->irq_lock, irqflags); - imr = I915_READ(VLV_IMR); - if (pipe == PIPE_A) - imr &= ~I915_DISPLAY_PIPE_A_VBLANK_INTERRUPT; - else - imr &= ~I915_DISPLAY_PIPE_B_VBLANK_INTERRUPT; - I915_WRITE(VLV_IMR, imr); i915_enable_pipestat(dev_priv, pipe, PIPE_START_VBLANK_INTERRUPT_ENABLE); spin_unlock_irqrestore(&dev_priv->irq_lock, irqflags); @@ -2366,17 +2359,10 @@ static void valleyview_disable_vblank(struct drm_device *dev, int pipe) { drm_i915_private_t *dev_priv = (drm_i915_private_t *) dev->dev_private; unsigned long irqflags; - u32 imr; spin_lock_irqsave(&dev_priv->irq_lock, irqflags); i915_disable_pipestat(dev_priv, pipe, PIPE_START_VBLANK_INTERRUPT_ENABLE); - imr = I915_READ(VLV_IMR); - if (pipe == PIPE_A) - imr |= I915_DISPLAY_PIPE_A_VBLANK_INTERRUPT; - else - imr |= I915_DISPLAY_PIPE_B_VBLANK_INTERRUPT; - I915_WRITE(VLV_IMR, imr); spin_unlock_irqrestore(&dev_priv->irq_lock, irqflags); } -- 1.8.4 _______________________________________________ Intel-gfx mailing list [email protected] http://lists.freedesktop.org/mailman/listinfo/intel-gfx
