On 8/2/2023 4:45 PM, Kandpal, Suraj wrote:
1.1
This change is required for DSC 1.1 because the current calculation is for DSC
1.2 and may get a calculated value which is not recommended by DSC 1.1, for
example, the calculated value at 8bpp becomes 15, not the value of 12
recommened by DSC 1.1.

Cc: Ankit Nautiyal <[email protected]>
Cc: Juha-Pekka Heikkil <[email protected]>
Signed-off-by: William Tseng <[email protected]>
---
  drivers/gpu/drm/i915/display/intel_vdsc.c | 17 ++++++++++++-----
  1 file changed, 12 insertions(+), 5 deletions(-)

diff --git a/drivers/gpu/drm/i915/display/intel_vdsc.c
b/drivers/gpu/drm/i915/display/intel_vdsc.c
index bd9116d2cd76..9b350f5f8ebb 100644
--- a/drivers/gpu/drm/i915/display/intel_vdsc.c
+++ b/drivers/gpu/drm/i915/display/intel_vdsc.c
@@ -72,11 +72,18 @@ calculate_rc_params(struct drm_dsc_config
*vdsc_cfg)
        int qp_bpc_modifier = (bpc - 8) * 2;
        u32 res, buf_i, bpp_i;

-       if (vdsc_cfg->slice_height >= 8)
-               vdsc_cfg->first_line_bpg_offset =
-                       12 + DIV_ROUND_UP((9 * min(34, vdsc_cfg-

This seem to be incorrect as per the spec this should have been first_line_bpg_offset = 12 + floor(0.09 * MIN (34, slice_height – 8))for slice_height ≥ 8

So instead of rounding up we should have just divided.


slice_height - 8)), 100);
-       else
-               vdsc_cfg->first_line_bpg_offset = 2 * (vdsc_cfg-
slice_height - 1);
+       if (vdsc_cfg->dsc_version_minor == 2) {
I think the check here should be for minor version 1 and move the code in this 
block to
the else block and vice versa as this 8 bpp corner case is applicable only to 
DSC 1.1
+               if (vdsc_cfg->slice_height >= 8)
+                       vdsc_cfg->first_line_bpg_offset =
+                               12 + DIV_ROUND_UP((9 * min(34, vdsc_cfg-
slice_height - 8)), 100);
+               else
+                       vdsc_cfg->first_line_bpg_offset = 2 * (vdsc_cfg-
slice_height - 1);
+       } else {
+               if (bpp == 8)
+                       rc->first_line_bpg_offset = 12;
+               else
+                       rc->first_line_bpg_offset = 15;
+       }
Add the section in DSC spec/ Cmodel from where one can verify this in comments

I think this is coming from the recommended/ required value from DSC 1.1.


Regards,

Ankit


Regards,
Suraj Kandpal
        /* Our hw supports only 444 modes as of today */
        if (bpp >= 12)
--
2.34.1

Reply via email to