Op 16-08-2019 om 10:04 schreef Lucas De Marchi:
> From: José Roberto de Souza <[email protected]>
>
> On TGL some registers moved from DDI to transcoder and the
> DisplayPort training sequence has a separate BSpec page.
>
> I started adding 'ifs' to the original intel_ddi_pre_enable_dp() but
> it was becoming really hard to follow, so a new and cleaner function
> for TGL was added with comments of all steps. It's similar to ICL, but
> different enough to deserve a new function
>
> The rest of DisplayPort enable and the whole disable sequences
> remained the same.
>
> BSpec: 49190
> Cc: Manasi Navare <[email protected]>
> Cc: Ville Syrjälä <[email protected]>
> Signed-off-by: José Roberto de Souza <[email protected]>
> Signed-off-by: Lucas De Marchi <[email protected]>
> ---
> drivers/gpu/drm/i915/display/intel_ddi.c | 134 ++++++++++++++++++++++-
> drivers/gpu/drm/i915/display/intel_dp.c | 8 +-
> 2 files changed, 134 insertions(+), 8 deletions(-)
>
> diff --git a/drivers/gpu/drm/i915/display/intel_ddi.c
> b/drivers/gpu/drm/i915/display/intel_ddi.c
> index 17d49c77faa0..5d971e9d0459 100644
> --- a/drivers/gpu/drm/i915/display/intel_ddi.c
> +++ b/drivers/gpu/drm/i915/display/intel_ddi.c
> @@ -1761,7 +1761,14 @@ void intel_ddi_set_vc_payload_alloc(const struct
> intel_crtc_state *crtc_state,
> I915_WRITE(TRANS_DDI_FUNC_CTL(cpu_transcoder), temp);
> }
>
> -void intel_ddi_enable_transcoder_func(const struct intel_crtc_state
> *crtc_state)
> +/*
> + * Returns the TRANS_DDI_FUNC_CTL value based on CRTC state.
> + *
> + * Only intended to be used by intel_ddi_enable_transcoder_func() and
> + * intel_ddi_config_transcoder_func().
> + */
> +static u32
> +intel_ddi_transcoder_func_reg_val_get(const struct intel_crtc_state
> *crtc_state)
> {
> struct intel_crtc *crtc = to_intel_crtc(crtc_state->base.crtc);
> struct intel_encoder *encoder = intel_ddi_get_crtc_encoder(crtc);
> @@ -1851,6 +1858,33 @@ void intel_ddi_enable_transcoder_func(const struct
> intel_crtc_state *crtc_state)
> temp |= DDI_PORT_WIDTH(crtc_state->lane_count);
> }
>
> + return temp;
> +}
> +
> +void intel_ddi_enable_transcoder_func(const struct intel_crtc_state
> *crtc_state)
> +{
> + struct intel_crtc *crtc = to_intel_crtc(crtc_state->base.crtc);
> + struct drm_i915_private *dev_priv = to_i915(crtc->base.dev);
> + enum transcoder cpu_transcoder = crtc_state->cpu_transcoder;
> + u32 temp;
> +
> + temp = intel_ddi_transcoder_func_reg_val_get(crtc_state);
> + I915_WRITE(TRANS_DDI_FUNC_CTL(cpu_transcoder), temp);
> +}
> +
> +/*
> + * Same as intel_ddi_enable_transcoder_func() but it do not set the enable
> bit
> + */
> +static void
> +intel_ddi_config_transcoder_func(const struct intel_crtc_state *crtc_state)
> +{
> + struct intel_crtc *crtc = to_intel_crtc(crtc_state->base.crtc);
> + struct drm_i915_private *dev_priv = to_i915(crtc->base.dev);
> + enum transcoder cpu_transcoder = crtc_state->cpu_transcoder;
> + u32 temp;
> +
> + temp = intel_ddi_transcoder_func_reg_val_get(crtc_state);
> + temp &= ~TRANS_DDI_FUNC_ENABLE;
> I915_WRITE(TRANS_DDI_FUNC_CTL(cpu_transcoder), temp);
> }
>
> @@ -3176,9 +3210,89 @@ static void intel_ddi_disable_fec_state(struct
> intel_encoder *encoder,
> POSTING_READ(ctl);
> }
>
> -static void intel_ddi_pre_enable_dp(struct intel_encoder *encoder,
> - const struct intel_crtc_state *crtc_state,
> - const struct drm_connector_state
> *conn_state)
> +static void tgl_ddi_pre_enable_dp(struct intel_encoder *encoder,
> + const struct intel_crtc_state *crtc_state,
> + const struct drm_connector_state *conn_state)
> +{
> + struct intel_dp *intel_dp = enc_to_intel_dp(&encoder->base);
> + struct drm_i915_private *dev_priv = to_i915(encoder->base.dev);
> + enum phy phy = intel_port_to_phy(dev_priv, encoder->port);
> + struct intel_digital_port *dig_port = enc_to_dig_port(&encoder->base);
> + bool is_mst = intel_crtc_has_type(crtc_state, INTEL_OUTPUT_DP_MST);
> + int level = intel_ddi_dp_level(intel_dp);
> +
> + intel_dp_set_link_params(intel_dp, crtc_state->port_clock,
> + crtc_state->lane_count, is_mst);
> +
> + /* 1.a got on intel_atomic_commit_tail() */
> +
> + /* 2. */
> + intel_edp_panel_on(intel_dp);
> +
> + /*
> + * 1.b, 3. and 4. is done by before this functions by
> + * haswell_crtc_enable()->intel_encoders_pre_pll_enable() and
> + * haswell_crtc_enable()->intel_enable_shared_dpll()
> + */
> +
> + /* 5. */
> + if (!intel_phy_is_tc(dev_priv, phy) ||
> + dig_port->tc_mode != TC_PORT_TBT_ALT)
> + intel_display_power_get(dev_priv,
> + dig_port->ddi_io_power_domain);
> +
> + /* 6. */
> + icl_program_mg_dp_mode(dig_port);
> +
> + /*
> + * 7.a - Steps in this function that should only be executed over MST
> + * master as MST encoders will only be executed on MST master as MST
> + * encoder have have it's own pre_enable() hook
> + */
> + intel_ddi_enable_pipe_clock(crtc_state);
> +
> + /* 7.b */
> + intel_ddi_config_transcoder_func(crtc_state);
> +
> + /* 7.d */
> + icl_disable_phy_clock_gating(dig_port);
> +
> + /* 7.e */
> + icl_ddi_vswing_sequence(encoder, crtc_state->port_clock, level,
> + encoder->type);
> +
> + /* 7.f */
> + if (intel_phy_is_combo(dev_priv, phy)) {
> + bool lane_reversal =
> + dig_port->saved_port_bits & DDI_BUF_PORT_REVERSAL;
> +
> + intel_combo_phy_power_up_lanes(dev_priv, phy, false,
> + crtc_state->lane_count,
> + lane_reversal);
> + }
> +
> + /* 7.g */
> + intel_ddi_init_dp_buf_reg(encoder);
> +
> + if (!is_mst)
> + intel_dp_sink_dpms(intel_dp, DRM_MODE_DPMS_ON);
> +
> + /* 7.c, 7.h, 7.i, 7.j */
> + intel_dp_start_link_train(intel_dp);
> +
> + /* 7.k */
> + intel_dp_stop_link_train(intel_dp);
> +
> + /* 7.l */
> + intel_dp_sink_set_decompression_state(intel_dp, crtc_state,
> + true);
> + intel_dp_sink_set_fec_ready(intel_dp, crtc_state);
See "DDI FEC" in bspec.
intel_dp_sink_set_fec_ready() needs to be called before link training,
intel_ddi_enable_fec() after.
Presumably this is the same for DSC.
> + intel_dsc_enable(encoder, crtc_state);
> +}
> +
> +static void hsw_ddi_pre_enable_dp(struct intel_encoder *encoder,
> + const struct intel_crtc_state *crtc_state,
> + const struct drm_connector_state *conn_state)
> {
> struct intel_dp *intel_dp = enc_to_intel_dp(&encoder->base);
> struct drm_i915_private *dev_priv = to_i915(encoder->base.dev);
> @@ -3244,6 +3358,18 @@ static void intel_ddi_pre_enable_dp(struct
> intel_encoder *encoder,
> intel_dsc_enable(encoder, crtc_state);
> }
>
> +static void intel_ddi_pre_enable_dp(struct intel_encoder *encoder,
> + const struct intel_crtc_state *crtc_state,
> + const struct drm_connector_state
> *conn_state)
> +{
> + struct drm_i915_private *dev_priv = to_i915(encoder->base.dev);
> +
> + if (INTEL_GEN(dev_priv) >= 12)
> + tgl_ddi_pre_enable_dp(encoder, crtc_state, conn_state);
> + else
> + hsw_ddi_pre_enable_dp(encoder, crtc_state, conn_state);
> +}
> +
> static void intel_ddi_pre_enable_hdmi(struct intel_encoder *encoder,
> const struct intel_crtc_state *crtc_state,
> const struct drm_connector_state
> *conn_state)
> diff --git a/drivers/gpu/drm/i915/display/intel_dp.c
> b/drivers/gpu/drm/i915/display/intel_dp.c
> index ebfcf183c7f1..1a8e041a5c43 100644
> --- a/drivers/gpu/drm/i915/display/intel_dp.c
> +++ b/drivers/gpu/drm/i915/display/intel_dp.c
> @@ -4007,13 +4007,13 @@ void intel_dp_set_idle_link_train(struct intel_dp
> *intel_dp)
> I915_WRITE(ctl, val);
>
> /*
> - * On PORT_A we can have only eDP in SST mode. There the only reason
> - * we need to set idle transmission mode is to work around a HW issue
> - * where we enable the pipe while not in idle link-training mode.
> + * Until TGL on PORT_A we can have only eDP in SST mode. There the only
> + * reason we need to set idle transmission mode is to work around a HW
> + * issue where we enable the pipe while not in idle link-training mode.
> * In this case there is requirement to wait for a minimum number of
> * idle patterns to be sent.
> */
> - if (port == PORT_A)
> + if (port == PORT_A && INTEL_GEN(dev_priv) < 12)
> return;
>
> if (intel_wait_for_register(&dev_priv->uncore, status,
_______________________________________________
Intel-gfx mailing list
[email protected]
https://lists.freedesktop.org/mailman/listinfo/intel-gfx
