On 13 February 2017 at 14:28, Rustu Yucel <[email protected]> wrote: > > İts ubuntu 16.10 and it was working smoothly till gqrx install. Gqrx website asked first remove some previous packs then I can not get signal. just 1 max signal then its stops. Help?
Which instructions are you following? Which packages did it ask you to remove before installation? As I asked in my previous email, what is the hardware you are running on? What is the output of hackrf_info? > On 13 Feb 2017, at 23:57, Dominic Spill <[email protected]> wrote: > > On 13 February 2017 at 13:37, Rustu Yucel <[email protected]> wrote: > > > > After I install gqrx (with guide of gqrx.dk website) I am not able to get samples from hack rf (firmware 2017.02.1). I am receiving this > > ~$ hackrf_transfer -f 102MHz -r /dev/null > > call hackrf_set_sample_rate(10000000 Hz/10.000 MHz) > > call hackrf_set_freq(102 Hz/0.000 MHz) > > You need to specify -f 102e6 or -f 102000000 to receive on 102MHz. > > > Stop with Ctrl-C > > 3.4 MiB / 1.000 sec = 3.4 MiB/second > > This data rate is very low, it should be around 20MiB/second. What is the host system that you are running on? Is it embedded hardware? > > > Exiting... hackrf_is_streaming() result: streaming terminated (-1004) > > Total time: 1.00012 s > > hackrf_stop_rx() done > > hackrf_close() done > > hackrf_exit() done > > fclose(fd) done > > exit > > > > Why only one sample and exiting after? Any help? > > Could you give us the output of hackrf_info ?
_______________________________________________ HackRF-dev mailing list [email protected] https://pairlist9.pair.net/mailman/listinfo/hackrf-dev
