Hi. I tried to measure throughput of HackRF One
My .grc flow like below:
Tx)
file source(.txt) -> packet encoder -> GMSK MOD -> osmocom sink
Rx)
osmocom source -> GMSK DEMOD -> packet decoder -> file sink
And I could get receiving data rate as bandwidth & Tx power.
I expected higher throughput as higher bandwidth(1.75MHz to 20MHz) & Tx
power(10db to -10db), but it didn’t.
Also, maximum throughput is limited in my case about 4Mbps.
I think it because of poor sending data rate.
So, I want to know how to control Tx data rate like MTU.
I considered bits per symbol of packet encoder, however, it doesn’t effect on
data rate under GMSK MOD (maybe)
Thanks for any replies !
Shawn.
_______________________________________________
HackRF-dev mailing list
[email protected]
https://pairlist9.pair.net/mailman/listinfo/hackrf-dev
