thank you for your quick answer, please how to record the streaming in int8 type
Regards; On Thu, Nov 19, 2015 at 9:40 PM, Karl Koscher <[email protected]> wrote: > You are recording complex floats. The intermediate frequency is your > frequency of interest minus what the HackRF is tuned to. If your HackRF is > tuned to 1.575 GHz but you want to decode the GPS L1 signal, then your IF > is 420 kHz. > > On Thu, Nov 19, 2015 at 1:36 PM, mourad ghafiri <[email protected]> > wrote: > >> I attached the flow graph for the recording as well as a real time >> spectrum , I'm not sure what blocks to use or what parameters to set for >> this block in order to have the right streaming. >> thanks for showing interest to the question >> >> On Thu, Nov 19, 2015 at 9:16 PM, Karl Koscher <[email protected] >> > wrote: >> >>> How are you recording the samples? >>> >>> On Thu, Nov 19, 2015 at 1:05 PM, mourad ghafiri < >>> [email protected]> wrote: >>> >>>> Hello; >>>> >>>> please any help to figure out what is the Intermediate Frequency used >>>> for HackRF in Gnuradio... >>>> >>>> I'm recording a streaming file for GPS and I don't know what is the >>>> appropriate type ( int; float...) and what is the appropriate IF to use in >>>> order to process that streaming in Matlab. >>>> >>>> Best Regards; >>>> >>>> _______________________________________________ >>>> HackRF-dev mailing list >>>> [email protected] >>>> https://pairlist9.pair.net/mailman/listinfo/hackrf-dev >>>> >>>> >>> >> >
_______________________________________________ HackRF-dev mailing list [email protected] https://pairlist9.pair.net/mailman/listinfo/hackrf-dev
