In general I think the directions are good, but there's no way the order is right. You'll want to run the hackrf install before installing gr-osmosdr. Use "brew uninstall" against both hackrf and gr-osmosdr, then run them again with hackrf first and gr-osmosdr second, so that the osmosdr configure/make detects libhackrf and uses it. You should be off and running after that.
-- Brian On Sat, Jan 10, 2015 at 4:29 PM, Jay Hamlin <[email protected]> wrote: > Brian- Thank you! > > Since I am on Macintosh, my step 1 command is: > otool -l /usr/local/Cellar/gqrx/HEAD/Gqrx.app/Contents/MacOs/Gqrx | > grep osmo > > And I get the exact same path as you with offset 24 except I have version > 0.1.5. > > Step 2 fails - ok, so osmodr did not get created with libhackrf compiled > in! This is a start. > > I am following the directions here: > https://github.com/andresv/homebrew-gnuradio > > The step for building osmodr I think is this one: > brew install gr-osmosdr gr-baz --HEAD > > Is that right? > > Thanks, > Jay. > > On Jan 10, 2015, at 2:24 PM, Brian Dickman <[email protected]> > wrote: > > A good first step is to make sure that your osmosdr is linked with > libhackrf. Perhaps there is an easier way to do this? Here's my approach. > > At a terminal prompt: > > 1) otool -l `which gqrx` | grep osmo > > (those are backticks up by the escape key, not single quotes) > > You should get back the full path to your libosmosdr dylib. Take that > filename and feed it into the next command (for example, mine says "name > /usr/local/lib/libgnuradio-osmosdr.0.1.2git.dylib (offset 24)" so I'll use > that path, but use the result you get): > > 2) otool -l /usr/local/lib/libgnuradio-osmosdr.0.1.2git.dylib | grep hackrf > > You should get a result back (for example, mine says "name > /usr/local/lib/libhackrf.0.dylib (offset 24)"). If you don't, then osmosdr > did not get created with libhackrf compiled in. You can also run without > the grep to see all the info that otool knows about libhackrf. > > -- > Brian > > On Sat, Jan 10, 2015 at 10:16 AM, Jay Hamlin <[email protected]> wrote: > >> I have tried hard to solve this problem on my own but I'm stuck and need >> help. I installed all the software on Macintosh using Homebrew following >> the instructions carefully. I used hackrf_spiflash and hackrf_cpldjtag to >> update the firmware and hackrf_info reports good information like >> everything is fine. But hackRF does not show up as a device in Gqrx and >> osmocom_fft reports no device found. I saw one other report like this in >> the archives but with no resolution. It seems like there must be a simple >> configuration or path wrong but I can't figure it out. Please help. >> Thanks. Jay. >> _______________________________________________ >> HackRF-dev mailing list >> [email protected] >> https://pairlist9.pair.net/mailman/listinfo/hackrf-dev >> > > >
_______________________________________________ HackRF-dev mailing list [email protected] https://pairlist9.pair.net/mailman/listinfo/hackrf-dev
