On Friday, 23 August 2024 01:32:39 BST Deri wrote: > The > difference is that version 7 returns this layer as all 255, and version 6.9 > returns it as all zeroes. Which means that although the png is embedded you > still can't see it because the whole image is transparent! > > My investigation continues.
Hi Peter, This is in fact documented as a change in v7:- http://www.imagemagick.org/script/porting.php#alpha "Alpha We support alpha now, previously opacity. With alpha, a value of 0 means that the pixel does not have any coverage information and is transparent; i.e. there was no color contribution from any geometry because the geometry did not overlap this pixel. A value of QuantumRange means that the pixel is opaque because the geometry completely overlapped the pixel. As a consequence, in version 7, the PixelInfo structure member alpha has replaced the previous opacity member. Another consequence is the alpha part of an sRGB value in hexadecimal notation is now reversed (e.g. #0000 is fully transparent)." Now that I have ascertained that this change is "official" I have released a change to gropdf which checks which version of ImageMagick is installed and behaves accordingly. The second issue, identify not returning the MediaBox correctly is a bit more hairy, so I have altered pdfpic.tmac so that pdfinfo is run first. So you should be able to run the new PDFPIC using ImageMagick 6.9 as well as 7. You can get a few surprises if you run PDFPIC without at least one of width or height. I have a pdf which has an 800x800 pixel jpeg embedded, it is a scan of a kodak instamatic 126 colour slide, 1 inch square. Identify reports the jpeg as 800x800, but if you run convert file.jpg file.pdf then identify (and pdfinfo) report the image as 72x72, and when run the picture takes up just one inch on the page. It has not really shrunk, convert has used meta-data in the jpeg which tells it that the scan was 800dpi so the original image was 1 inch square so it has set the pdf MediaBox to that size. It is safest to specify the size you want the image to take on the page rather than trying to create an image of the size you want, just take into account the resolution of the device the pdf will be consumed and make sure the image has sufficient pixels, 100 dpi should be fine viewing on most screens, but you may need significantly more it the pdf is to be printed. When viewing high dpi images on a screen it may appear a bit disappointing because some of the detail may not show, i.e. a 300 dpi image on a 100 dpi screen - the viewer has to sample 9 pixels to produce 1 screen pixel, and it is further complicated by the scaling of the window manager. Cheers Deri
