Just fixed it by selecting "Restore all Options to Default Setting" in the
Help menu and then setting again
Geometry.OCCTargetUnit = "MM"
Unfortunately because of the general option reset I can't tell which option
created the problem but at least now the problem is solved.
Marco
Il martedì 17 novembre 2020, 10:01:47 CET, Christophe Geuzaine
<[email protected]> ha scritto:
> On 13 Nov 2020, at 19:37, Marco Antolovic <[email protected]> wrote:
>
> Hi all,
>
> I'm trying to mesh the attached step file and I'm experiencing a strange Gmsh
> behavior when I change Geometry.OCCTargetUnit = "M" to Geometry.OCCTargetUnit
> = "MM"
>
> Keeping all other options unchanged, when I use "M" the domain is meshed and
> I can see the mesh but I when I switch to "MM" although meshing process is
> shown (and completed succesfully with 22153 nodes 112879 elements) in the
> message console the mesh is nowhere to be seen.
>
Did you figure it out? I cannot reproduce the issue.
Christophe
> The min/max element size should not be a problem (for me it is set to 0/2).
>
> My Gmsh Version is 4.7.0-git-0dc1450
>
> Any help is much appreciated.
>
> Thanks,
>
> Marco
>
> <4_layers_V02.step>_______________________________________________
> gmsh mailing list
> [email protected]
> http://onelab.info/mailman/listinfo/gmsh
—
Prof. Christophe Geuzaine
University of Liege, Electrical Engineering and Computer Science
http://people.montefiore.ulg.ac.be/geuzaine
_______________________________________________
gmsh mailing list
[email protected]
http://onelab.info/mailman/listinfo/gmsh
