Trying to get a Microtek C6 scanner working. I haev generic scsi support loaded as module, hotplug does its thing, and I get the following. Any tips on how I can follow up on this? Would really like to get it going.
usb 3-1: new full speed USB device using uhci_hcd and address 8 usb 3-1: USB disconnect, address 8 usb 1-2: USB disconnect, address 10 usb 1-2: new full speed USB device using uhci_hcd and address 11 microtek usb (rev 0.4.3): model Phantom C6 is not known to be fully supported, reports welcome! scsi8 : microtekX6 microtek usb (rev 0.4.3): could not submit URB! Error was -1 usb 1-2: reset full speed USB device using uhci_hcd and address 11 usb 1-2: can't restore configuration #1 (error=-71) scsi: Device offlined - not ready after error recovery: host 8 channel 0 id 0 lun 0 usb 1-2: USB disconnect, address 11 usb 1-2: new full speed USB device using uhci_hcd and address 12 microtek usb (rev 0.4.3): model Phantom C6 is not known to be fully supported, reports welcome! scsi9 : microtekX6 microtek usb (rev 0.4.3): could not submit URB! Error was -1 usb 1-2: reset full speed USB device using uhci_hcd and address 12 scsi: Device offlined - not ready after error recovery: host 9 channel 0 id 0 lun 0 -- It is better to die on your feet than to live on your knees. -- gentoo-user@gentoo.org mailing list
