Howdy, I'm playing around with my NAS box again. I ran into a network issue. I sorta forgot I unplugged the network cable so obviously, it made it difficult to ssh into the thing from my main rig. After hooking up a monitor and keyboard, I found the problem and plugged the network cable back in. ROFLMBO Told y'all I forget stuff.
Anyway, while investigating this, I realized the network setup is not like on my old rig. Heck, I couldn't even figure out how to restart it other than switching to the boot runlevel and back to default, or rebooting. After a bit, I think I can restart DHCP and it restart the network. I figured out the cable was unplugged before trying that. I'm wanting to set up the NAS box network the same way as my main rig. That's the old manual way. I went back to the install handbook, that's what I followed when installing on my main rig. Thing is, it has been updated and the old way isn't all there. I followed what little bit is there but it defaults back to the new way. I'm sure I'm missing some file I need to edit but I can't figure out which one it is. So, is there a way to get the old instructions again? The ones I followed several years ago for my main rig? I tried searching but it seems they all gone. Maybe there is a place I'm not aware of tho. Basically, I want to be able to start/stop/restart enp3s0 as a service and have it in a runlevel. Also, I'd like to get the install handbook as one large page. My intention is to save it locally for future reference as it is now. I may even print a copy. I looked at all the places that have different options but can't find the whole thing as one large page. I looked under several drop down menus and such. A long time ago, it was a option. I just can't find it now. May that option isn't available anymore. I wish I had a copy of the one from several years ago. Back when I installed on my main rig. Some network info. Lines that are commented out are options I tried but didn't work. It was worth a shot. o_O nas / # grep -r '!net' /etc/ /etc/rc.conf:rc_hotplug="!net.*" nas / # grep -r 'enp3s0' /etc/ /etc/resolv.conf:# Generated by dhcpcd from enp3s0.dhcp /etc/conf.d/net:config_enp3s0="dhcp" /etc/conf.d/net:dns_servers_enp3s0="8.8.8.8 8.8.4.4" /etc/conf.d/net:#config_enp3s0="10.0.0.5" nas / #nas / # ifconfig -s enp3s0 Iface MTU RX-OK RX-ERR RX-DRP RX-OVR TX-OK TX-ERR TX-DRP TX-OVR Flg enp3s0 1500 16802 0 0 0 17196 0 0 0 BMRU nas / # Thoughts? If I had the old install info, I think I could get it to work. I did last time. ;-) Dale :-) :-)
