Looking for anyone that can offer advice on connecting a Motorola C380 mobile phone to my gentoo Linux system via the USB interface.
When I connect the phone, I see the following in /var/log/messages: usb 1-2: new full speed USB device using uhci_hcd and address 2 usb 1-2: device descriptor read/64, error -71 usb 1-2: device descriptor read/64, error -71 usb 1-2: new full speed USB device using uhci_hcd and address 3 usb 1-2: device descriptor read/64, error -71 A disconnect and reconnect produces: usb 1-2: USB disconnect, address 3 usb 1-2: new full speed USB device using uhci_hcd and address 4 usb 1-2: device descriptor read/64, error -71 usb 1-2: device descriptor read/64, error -71 usb 1-2: new full speed USB device using uhci_hcd and address 5 usb 1-2: device descriptor read/64, error -71 Any idea what the error messages indicate, and should I be worried about them? Is it normal that the addresses appear to be monotonically increasing with each successive connect? While connected, /proc/bus/usb/devices contains: T: Bus=01 Lev=01 Prnt=01 Port=01 Cnt=01 Dev#= 7 Spd=12 MxCh= 0 D: Ver= 1.10 Cls=02(comm.) Sub=00 Prot=00 MxPS= 8 #Cfgs= 1 P: Vendor=22b8 ProdID=4902 Rev= 0.01 S: Manufacturer=Motorola Inc. S: Product=Motorola Phone (C380) C:* #Ifs= 2 Cfg#= 1 Atr=c0 MxPwr= 20mA I: If#= 0 Alt= 0 #EPs= 1 Cls=02(comm.) Sub=02 Prot=01 Driver=(none) E: Ad=89(I) Atr=03(Int.) MxPS= 16 Ivl=10ms I: If#= 1 Alt= 0 #EPs= 2 Cls=0a(data ) Sub=00 Prot=00 Driver=(none) E: Ad=01(O) Atr=02(Bulk) MxPS= 32 Ivl=0ms E: Ad=82(I) Atr=02(Bulk) MxPS= 32 Ivl=0ms I have tried emerge'ing gnoki, but it doesn't seem to succeed in connecting, but perhaps there is some configuration that I havn't stumbled across yet. anyone have any experience or suggestions on what to try with this? Thanks, DigbyT -- Digby R. S. Tarvin [EMAIL PROTECTED] http://www.digbyt.com -- gentoo-user@gentoo.org mailing list
