Dell latitude E6510, ~amd64
kernel: 2-6.34 (gentoo sources)
lspci -vnn
03:00.0 Network controller [0280]: Broadcom Corporation Device [14e4:4727] (rev
01)
Subsystem: Dell Device [1028:0010]
Flags: bus master, fast devsel, latency 0, IRQ 11
Memory at e6e00000 (64-bit, non-prefetchable) [size=16K]
Capabilities: [40] Power Management version 3
Capabilities: [58] Vendor Specific Information: Len=78 <?>
Capabilities: [48] MSI: Enable- Count=1/1 Maskable- 64bit+
Capabilities: [d0] Express Endpoint, MSI 00
Capabilities: [100] Advanced Error Reporting
Capabilities: [13c] Virtual Channel
Capabilities: [160] Device Serial Number 00-00-00-ff-ff-89-78-e4
Capabilities: [16c] Power Budgeting <?>
If I understood the wiki correctly, with the new kernel I don't have to
run b43-fwcutter, but just emerge the b43-firmware. I have done so and
also have the fwcutter emerged.
I have build b43 as both a kernel module and as a built-in component.
But neither eth1 nor wlan0 exist for either kernel configuration (eth0
is the hardwired ethernet)
I suspect there is another step I should be doing and would appreciate
any help you can offer.
thanks,
allan
