I've got multiple NIC's in the box (one for each port, to each room in the house). However, that leaves me one short to connect the cable modem. I connected it via USB and using the CDCEther driver (as a module) I do see the following in my dmesg log... In my /etc/conf.d/net I have all (eth0 to eth5) of my "cards" configured to use DHCP (which the cable modem will need in the end). However, eth5 is saying "can't start" or some other words for "I failed but I'm not going to tell you why". I don't see anything in the logs though... any ideas?
Thanks!
Matt
CDCEther.c: CDCEther.c: 0.98.6 7 Jan 2002 Brad Hards and another
usb.c: registered new driver CDCEther
CDCEther.c: Ethernet information found at device configuration. Trying to use it anyway.
CDCEther.c: Found Header descriptor, CDC version 110.
CDCEther.c: Imperfect filtering support - need sw hashing
CDCEther.c: Can't use SetEthernetMulticastFilters request
CDCEther.c: detected BULK OUT packets of size 64
CDCEther.c: interrupt address: 5
CDCEther.c: interrupt interval: 64
CDCEther.c: eth5: Motorola Corporation SB4100 USB Cable Modem 002040D15FBF
CDCEther.c: eth5: 00:20:40:D1:5F:BF
CDCEther.c: eth5: set multicast filters
CDCEther.c: eth5: set multicast filters
CDCEther.c: eth5: set multicast filters
CDCEther.c: eth5: too many MC filters for hardware, using allmulti
CDCEther.c: eth5: too many MC filters for hardware, using allmulti
CDCEther.c: rx status -84
CDCEther.c: BULK IN callback but driver is not active!
CDCEther.c: got intr callback
CDCEther.c: eth5: set multicast filters
CDCEther.c: eth5: too many MC filters for hardware, using allmulti
CDCEther.c: eth5: too many MC filters for hardware, using allmulti
CDCEther.c: eth5: too many MC filters for hardware, using allmulti
CDCEther.c: eth5: too many MC filters for hardware, using allmulti
CDCEther.c: rx status -84
CDCEther.c: BULK IN callback but driver is not active!
CDCEther.c: got intr callback
-- [EMAIL PROTECTED] mailing list
