On 22/05/2019 16:06, Florian Weimer wrote: > * Szabolcs Nagy: > >> AAELF64: in the Symbol Table section add >> >> st_other Values >> The st_other member of a symbol table entry specifies the symbol's >> visibility in the lowest 2 bits. The top 6 bits are unused in the >> generic ELF ABI [SCO-ELF], and while there are no values reserved for >> processor-specific semantics, many other architectures have used these >> bits. >> >> The defined processor-specific st_other flag values are listed in >> Table 4-5-1. >> >> Table 4-5-1, Processor specific st_other flags >> +------------------------+------+---------------------+ >> |Name | Mask | Comment | >> +------------------------+------+---------------------+ >> |STO_AARCH64_VARIANT_PCS | 0x80 | The function | >> | | | associated with the | >> | | | symbol may follow a | >> | | | variant procedure | >> | | | call standard with | >> | | | different register | >> | | | usage convention. | >> +------------------------+------+---------------------+ >> >> A symbol table entry that is marked with the STO_AARCH64_VARIANT_PCS >> flag set in its st_other field may be associated with a function that >> follows a variant procedure call standard with different register >> usage convention from the one defined in the base procedure call >> standard for the list of argument, caller-saved and callee-saved >> registers [AAPCS64]. The rules in the Call and Jump relocations >> section still apply to such functions, and if a subroutine is called >> via a symbol reference that is marked with STO_AARCH64_VARIANT_PCS >> then code that runs between the calling routine and called subroutine >> must preserve the contents of all registers except IP0, IP1 and the >> condition code flags [AAPCS64]. > > Can you clarify if there has to be a valid stack at this point which can > be used during the call transfer? What about the stack alignment > requirement?
the intention is to only allow 'register usage convention' to be relaxed compared to the base PCS (which has rules for stack etc), and even the register usage convention has to be compatible with the 'Call and Jump relocations section' which essentially says that veneers inserted by the linker between calls can clobber IP0, IP1 and the condition flags. i.e. a variant pcs function follows the same rules as base pcs, but it may use different caller-/callee-saved/argument regiseters. when SVE pcs is merged into the current AAPCS document, then i hope the 'variant pcs' term used here will be properly specified so the ELF ABI will just refer back to that.
