On 2018-06-27 21:22, Rainer Orth wrote: > Hi Jeff, > >>> So add an option for disabling build and install of libgcov and the >>> related host tools. >>> >>> 2018-06-10 Rasmus Villemoes <[email protected]> >>> >>> gcc/ >>> * configure.ac: Add --disable-gcov option. >>> * configure: Regenerate. >>> * Makefile.in: Honour @enable_gcov@. >>> * doc/install.texi: Document --disable-gcov. >>> >>> libgcc/ >>> * configure.ac: Add --disable-gcov option. >>> * configure: Regenerate. >>> * Makefile.in: Honour @enable_gcov@. >> OK. Presumably you're going through the process to get write access. >> Once that's wrapped up you can install this patch. > > this patch badly broke all -fprofile-generate/-fprofile-use tests in the > default case like this: > > UNRESOLVED: g++.dg/bprob/g++-bprob-1.C compilation, -O0 > -fbranch-probabilities > FAIL: g++.dg/bprob/g++-bprob-1.C compilation, -O0 -fprofile-arcs > > ld: fatal: library -lgcov: not found > collect2: error: ld returned 1 exit status > compiler exited with status 1 > FAIL: g++.dg/bprob/g++-bprob-1.C compilation, -g -fprofile-arcs > > libgcov.a is not copied over from libgcc to gcc due to a typo in > libgcc/Makefile.in. Fixed as follows; will install as obvious once > bootstrap has finished. >
I'm terribly sorry about that! I was sure I had tested all of --enable-gcov, --disable-gcov and none of those, and convinced myself that the default behaviour was unchanged. Thanks for spotting the problem and fixing it. I will try to be much more careful in the future. Rasmus
