Good afternoon,
Quick question about unpacking:
The instructions I have from a previous staff member said to do this:
In folder where files are going, type: unpacksdcmdir -src <location of scans>
-targ . -scanonly scanout.txt
So what I submit is:
unpacksdcmdir -src
/cluster/archive/338/siemens/Prisma_fit-67026-20220208-132737-000260 -targ .
-scanonly scanout.txt
When I do that, it just makes the files:
dicomdir.sumfile scanout.txt unpack.log
I’m trying to use the dcmunpack command instead. From following the template on
the website, I’ve been trying the following commands:
[pandas:Pandas57UC] (nmr-stable6-env) dcmunpack -src
/cluster/archive/338/siemens/Prisma_fit-67026-20220208-132737-000260 -index-out
dcm.index.dat
{lots of other content here, so let’s skip to….}
dcmunpack done
[pandas:Pandas57UC] (nmr-stable6-env) dcmunpack -src
/cluster/archive/338/siemens/Prisma_fit-67026-20220208-132737-000260 -index-in
dcm.index.dat -targ .
ERROR: need input runs
How should I specify input runs?
Thanks,
Sarah
_______________________________________________
Freesurfer mailing list
[email protected]
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Mass General Brigham
Compliance HelpLine at https://www.massgeneralbrigham.org/complianceline
<https://www.massgeneralbrigham.org/complianceline> .
Please note that this e-mail is not secure (encrypted). If you do not wish to
continue communication over unencrypted e-mail, please notify the sender of
this message immediately. Continuing to send or respond to e-mail after
receiving this message means you understand and accept this risk and wish to
continue to communicate over unencrypted e-mail.
