2010/10/29 Adam Vande More <[email protected]>: > On Fri, Oct 29, 2010 at 7:53 AM, dan <[email protected]> wrote: > >> On 10/29/10 13:22, Adam Vande More wrote: >> >>> On Fri, Oct 29, 2010 at 6:13 AM, dan<[email protected]> wrote: >>> >>> Thank you for your research and prompt response. The module was >>>> available. >>>> I tried both: kldload in command line and adding it in loader.conf. >>>> >>>> Note. In case the module has not been been loaded,as a user, here, one >>>> gets >>>> 2 messages >>>> "mount_msdosfs: cannot find or load msdosfs_iconv kernel module" >>>> AND >>>> >>>> "mount_msdosfs: msdosfs_iconv: Operation not permitted" >>>> >>>> I wonder what Operation is not permitted as a user and what rights the >>>> user >>>> needs. >>>> >>> >>> >>> sysctl vfs.usermount=1 >>> >>> Although it doesn't seem correct that you can mount that FS if it's >>> already >>> been mounted previously by root when that sysctl is at 0. >>> >>> >> Hello >> >> vfs.usermount is already set. In fact, I can readily mount the filesystem >> if I do not specify "-L ...". >> >> I did mount and then soon unmount the filesystem as root with "-L ...". > > > I see now. The loading of the kernel module is not permitted as I think the > mount command attempts to load it if necessary. I'm not aware of any method > of granting access to user which would allow them to load/unload kernel > modules. Only root level privs can do that. > > > -- > Adam Vande More > _______________________________________________ > [email protected] mailing list > http://lists.freebsd.org/mailman/listinfo/freebsd-questions > To unsubscribe, send any mail to "[email protected]" >
I have the same trouble, I usually mount device by user with vfs.usermount=1 but for libiconv I need root... -- Demelier David _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[email protected]"
