Hi! > > SSD or spinning drives ? > > > > > I have 3.6 Gb of RAM and 2 Gb of swap. > > > > Run top and check the state of ARC. > > > > I think it needs much more RAM. > > I don't think it is a SSD (it has cylinders, sectors etc.). > If you can tell me a way to check it I will be glad to do it. > This is the output of diskinfo -v /dev/ada0 in case it answers the question: > > /dev/ada0 > 512 # sectorsize > 320072933376 # mediasize in bytes (298G) > 625142448 # mediasize in sectors > 4096 # stripesize > 0 # stripeoffset > 620181 # Cylinders according to firmware. > 16 # Heads according to firmware. > 63 # Sectors according to firmware. > HGST HTS545032A7E680 # Disk descr.
This is a HGST drive, spinning, no SSD. > TMA45DZG06UX8R # Disk ident. > No # TRIM/UNMAP support > 5400 # Rotation rate in RPM > Not_Zoned # Zone Mode > > These are are lines of top's header (poudriere is building one of the ports I > think > might be problematic): > > CPU: 32.8% user, 4.8% nice, 8.3% system, 0.5% interrupt, 53.5% idle > Mem: 1200M Active, 332M Inact, 32M Laundry, 2084M Wired, 187M Free > ARC: 1122M Total, 649M MFU, 323M MRU, 1371K Anon, 16M Header, 133M Other > 401M Compressed, 1064M Uncompressed, 2.65:1 Ratio So, when it's slow during builds, it's most probably swapping. -- [email protected] +49 171 3101372 2 years to go ! _______________________________________________ [email protected] mailing list https://lists.freebsd.org/mailman/listinfo/freebsd-ports To unsubscribe, send any mail to "[email protected]"
