On Sun, 2003-11-16 at 20:14, Daryl Chance wrote: > I am currently not able to load my vinum array > (haven't tried to revert back to pre-statfs source) > after I built a new kernel and world. I upgraded the > recommended way (installkernel, reboot, single user > mode, installworld, etc) and when my box boots I get > "vinum loaded, no drives found". When I go to > kldunload vinum, it unloads but I get the error: > > vinum: exiting with malloc table inconsistency at > 0xc2f49400 from vinumio.c:755 > vinum: unloaded > > I checked the pr's, but haven't seen anything yet > listed in there. Should I do a sendpr? I'm basically > using the generic conf, with the exception that I've > removed 486 and 586 and changed the ident. > > I don't have a lint config, so i don't know how to > compile vinum into the kernel to test if that fixes > it. If theres anymore info needed, I'd be glad to > give access to the box or email a dmesg.
I'm getting the same (no drives/subdisks/plexes/volumes found) trying to upgrade from a Nov 11 kernel/userland to Nov 16th kernel. I tried seeing if using a Nov 16th vinum binary would load them, but after doing a stop/start, the system paniced, and it seems my swap is too small to dump on. Kernel was built using configure MYKERNEL; cd ../compile/MYKERNEL; make depend all install instead of buildkernel. DDB enabled but no invariants/witness, not sure what else from my config might be applicable. -- Eric Anholt [EMAIL PROTECTED] http://people.freebsd.org/~anholt/ [EMAIL PROTECTED] _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-current To unsubscribe, send any mail to "[EMAIL PROTECTED]"
