spec_getpages(ad4s1d) I/O read failure (error=5)
-Derek
At 02:53 PM 9/20/2003 -0500, Derek Ragona wrote:
The 9/19 snapshot has the same issues.
I will try to cvsup it and build a new kernel, if I can.
-Derek
At 05:36 AM 9/20/2003 -0500, Derek Ragona wrote:This was using the 9/18 snapshot, I tried to cvsup it to the most current, but the drive errors prevent the update.
I just reloaded with the 9/19 snapshot, and will report if the error still exists.
As for the hardware, it is all brand new hardware, and the system dual boots, the other OS has no issues.
-Derek
At 10:07 AM 9/20/2003 +0200, Soren Schmidt wrote:It seems Derek Ragona wrote:
> I have a single SATA drive on an Adaptec 1210SA card.
>
> The drive will give a write error warning a few times, then will repeatedly
> give:
> ad4: timeout sending command=ca
>
> The only recovery is the reset switch, reboot single-user fsck, and then
> come back up in multiuser.
>
> These errors occur with disk access, but not with a predictable nature (not
> on large files, or small files, etc.)
And you are on an uptodate -current ?
If so I'd suspect HW ...
-Søren_______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-current To unsubscribe, send any mail to "[EMAIL PROTECTED]"_______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-current To unsubscribe, send any mail to "[EMAIL PROTECTED]"
_______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-current To unsubscribe, send any mail to "[EMAIL PROTECTED]"
