Further playing... Disabled UDMA access to no success, however it will install if I install to a secondary disk....
Go figure... still kinda wanna be able to run it on primary.... thoughts> CH On Tuesday, October 15, 2002, at 01:58 PM, Colin Harford wrote: > > > System: Asus A7M266-D wAMD-768 Chipset, on dual Athalon MP 1900, 512 > MB ram, generic ATI card and Intel Pro 100 nic. > > (dmesg currently unavailable...) > > When I try to install FreeBSD-current based on snapshot bootable CD > (most recent) I get the following when trying to setup partitions.... > > > Debug: installCommit: System state is "init" > Debug: diskpartitionwrite: Examining 1 devices > Debug: Notify: writing partition information to device ad1 > ad1: hard error reading fsbn 65 (ad1 bn 65, cn 0 tn 1 sn 2) trying > PIO mode > ad1 hard errer reading fsbn 65 (ad1 bn 65, cn 0 tn 1 sn 2) states = > 59 error = 40 > Debug: Signal 11 caught! that's bad! > > > > I have by default 3 60GB ATA Maxtor drives in the tower. I have > removed the 2 on the secondary and the install still fails. I have > tried reversing the order of the disk (HD as either master or slave > and it still fails). I have tried one of the two other disks and I > have the same problem with it as well. > > > > This problem alternates between finding my primary drives or not > finding my primary devices on boot. > > > Any ideas? > > (Plug and Pray bios and all that jazz have been disabled). > > > > To Unsubscribe: send mail to [EMAIL PROTECTED] > with "unsubscribe freebsd-current" in the body of the message > To Unsubscribe: send mail to [EMAIL PROTECTED] with "unsubscribe freebsd-current" in the body of the message
