>
>
>Ok, so this is my failure. :( Sorry. I will look at it as soon as
>I get to decent internet connection. Right now I am on very bad GPRS.
>
>Can you please show your rc.conf (the network related part)?
>
>
>--
>Totus tuus, Glebius.
Here you go:
/etc/hosts:
::1 localhost localhost.pozo.com
127.0.0.1 localhost localhost.pozo.com
/etc/rc.conf:
ifconfig_lo0="inet 127.0.0.1" # default loopback device configuration.
ifconfig_bge0="inet 192.168.0.5 netmask 255.255.255.0"
defaultrouter="192.168.0.1" # Set to default gateway
ipv6_network_interfaces="auto" # List of IPv6 network interfaces
# (or "auto" or "none").
ipv6_activate_all_interfaces="NO" # If NO, interfaces which have no
ipv6_defaultrouter="NO" # Set to IPv6 default gateway (or NO).
ipv6_static_routes="" # Set to static route list (or leave
empty).
#ipv6_static_routes="xxx" # An example to set
fec0:0000:0000:0006::/64
# route toward
loopback interface.
#ipv6_route_xxx="fec0:0000:0000:0006:: -prefixlen 64 ::1"
ipv6_gateway_enable="NO" # Set to YES if this host will be a
gateway.
ipv6_cpe_wanif="NO" # Set to the upstram interface
name if this
# node will work as a
router to forward IPv6
# packets not
explicitly addressed to itself.
ipv6_privacy="NO" # Use privacy address on RA-receiving
IFs
# (RFC 4941)
route6d_enable="NO" # Set to YES to enable an IPv6 routing
daemon.
route6d_program="/usr/sbin/route6d" # Name of IPv6 routing daemon.
route6d_flags="" # Flags to IPv6 routing daemon.
#route6d_flags="-l" # Example for route6d with only IPv6
site local
# addrs.
#route6d_flags="-q" # If you want to run a routing
daemon on an end
# node, you should stop
advertisement.
#ipv6_network_interfaces="ed0 ep0" # Examples for router
# or static
configuration for end node.
# Choose correct prefix
value.
#ipv6_prefix_ed0="fec0:0000:0000:0001 fec0:0000:0000:0002" # Examples for rtr.
#ipv6_prefix_ep0="fec0:0000:0000:0003 fec0:0000:0000:0004" # Examples for rtr.
ipv6_default_interface="NO" # Default output interface for
scoped addrs.
# This works only with
#
ipv6_gateway_enable="NO".
That pretty much it, nothing special
I haven't made any changes to it in over 2 years.
The only thing about 1 year ago I enabled:
### Network link/usability verification options
netwait_enable="YES" # Enable rc.d/netwait (or NO)
netwait_ip="192.168.0.1" # IP addresses to be pinged by netwait.
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
_______________________________________________
freebsd-current@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-current
To unsubscribe, send any mail to "freebsd-current-unsubscr...@freebsd.org"
