I have problem with my newly bought D-link DFE530TX on my -current
(which is very new).
I have tested my NIC using the master/slave mode program came with my
NIC with my room mate. And the results show the NIC work correctly.
The most strange thing is that I can see the ethernet address of the
other ip, see the following infomation. But I can't get the interface
to work at all.
Also, I tested replacing my de0 (which connects the outside world)
with vr0. It doesn't work at all, but I can still get the ethernet
address of other nodes shown in the routing table.
Here are some output which might be useful to determine the problem.
# dmesg | grep vr0
vr0: <VIA VT3043 Rhine I 10/100BaseTX> rev 0x06 int a irq 12 on pci0.19.0
vr0: Ethernet address: 00:80:c8:ef:82:09
vr0: autoneg complete, link status good (half-duplex, 10Mbps)
vr0: selecting MII, 10Mbps, half duplex
# ifconfig vr0
vr0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
inet 192.168.100.2 netmask 0xffffff00 broadcast 192.168.100.255
ether 00:80:c8:ef:82:09
media: 10baseT/UTP (10baseT/UTP <half-duplex>)
supported media: autoselect 100baseTX <full-duplex> 100baseTX
<half-duplex> 100baseTX 10baseT/UTP <full-duplex> 10baseT/UTP 10baseT/UTP
<half-duplex>
# netstat -rn
Routing tables
Internet:
Destination Gateway Flags Refs Use Netif Expire
default 140.112.240.254 UGSc 10 0 de0
127.0.0.1 127.0.0.1 UH 1 120 lo0
140.112.240/24 link#1 UC 0 0 de0
140.112.240.59 0:80:c8:46:1e:d4 UHLW 5 1359 lo0
140.112.240.60 0:80:c8:69:96:3c UHLW 5 178 de0 1114
140.112.240.254 0:0:1d:ce:d3:7d UHLW 11 0 de0 839
140.112.240.255 ff:ff:ff:ff:ff:ff UHLWb 0 1 de0
192.168.100 link#2 UC 0 0 vr0
192.168.100.1 0:80:c8:ef:3c:3f UHLW 0 15 vr0 1158
^^^^^^^^^^^^^^^^
192.168.100.2 0:80:c8:ef:82:9 UHLW 0 3 lo0
192.168.100.255 ff:ff:ff:ff:ff:ff UHLWb 0 1 vr0
# ipfw list
ipfw: getsockopt(IP_FW_GET): Protocol not available
To Unsubscribe: send mail to majord...@freebsd.org
with "unsubscribe freebsd-current" in the body of the message
