Doug Rabson wrote:
>
> > Here, it might be the opposite. The normal sio probes pick up the
> > pnp modem just fine, and then perhaps pnp comes along and trounces
> > on what has already been setup/configured.
>
> Could you try this patch for me. It attempts to disable pnp devices before
> running the regular probes. This allows it to 'hide' those devices from
> the heuristic probes so that they don't get seen twice when the pnp probe
> happens.
[ Patch elided ]
This stops the kernel from hanging. The serial device (sio2) doesn't get
detected during the regular probes and the pnp probe detects it. But the
pnp probe detects it at the wrong IRQ (5 instead of 11).
Here's an excerpt of a verbose boot:
sio0: irq maps: 0x801 0x811 0x801 0x801
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1: irq maps: 0x801 0x809 0x801 0x801
sio1 at port 0x2f8-0x2ff irq 3 on isa0
sio1: type 16550A
sio2: configured irq 11 not in bitmap of probed irqs 0
sio2: irq maps: 0x801 0x801 0x801 0x801
sio2: probe failed test(s): 0 1 2 4 6 7 9
ppc: parallel port found at 0x378
ppc0: ECP SPP ECP+EPP SPP
ppc0 at port 0x378-0x37f irq 7 on isa0
ppc0: SMC-like chipset (ECP/EPP/PS2/NIBBLE) in COMPATIBLE mode
ppc0: FIFO with 16/16/9 bytes threshold
plip: irq 7
plip0: <PLIP network interface> on ppbus 0
bpf: lp0 attached
lpt0: <generic printer> on ppbus 0
lpt0: Interrupt-driven port
ppi0: <generic parallel i/o> on ppbus 0
unknown0: <SupraExpress 56i Sp V.90> at port 0x3e8-0x3ef irq 5 on isa0
What's the unknown0? Shouldn't that be sio2? Do we need the logical
device ID?
>From pnpinfo -v:
Card assigned CSN #1
Vendor ID SUP2480 (0x8024b04e), Serial Number 0x00001334
PnP Version 1.0, Vendor Version 0
Device Description: SupraExpress 56i Sp V.90
Logical Device ID: SUP2480 0x8024b04e #0
Device supports I/O Range Check
Compatible Device ID: SUP2080 (8020b04e)
[ See my original Email for a full listing. ]
CSN SUP2480 (0x8024b04e), Serial Number 0x00001334
Logical device #0
IO: 0x03e8 0x0000 0x0000 0x0000 0x0000 0x0000 0x0000 0x0000
IRQ 11 0
DMA 4 0
IO range check 0x00 activate 0x01
Dan Eischen
[EMAIL PROTECTED]
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-current" in the body of the message
